mirror of https://gitee.com/openkylin/linux.git
50 lines
1.5 KiB
Plaintext
50 lines
1.5 KiB
Plaintext
|
* General Purpose Input Output (GPIO) bus.
|
||
|
|
|
||
|
|
Properties:
|
||
|
|
- compatible: "cavium,octeon-3860-gpio"
|
||
|
|
|
||
|
|
Compatibility with all cn3XXX, cn5XXX and cn6XXX SOCs.
|
||
|
|
|
||
|
|
- reg: The base address of the GPIO unit's register bank.
|
||
|
|
|
||
|
|
- gpio-controller: This is a GPIO controller.
|
||
|
|
|
||
|
|
- #gpio-cells: Must be <2>. The first cell is the GPIO pin.
|
||
|
|
|
||
|
|
- interrupt-controller: The GPIO controller is also an interrupt
|
||
|
|
controller, many of its pins may be configured as an interrupt
|
||
|
|
source.
|
||
|
|
|
||
|
|
- #interrupt-cells: Must be <2>. The first cell is the GPIO pin
|
||
|
|
connected to the interrupt source. The second cell is the interrupt
|
||
|
|
triggering protocol and may have one of four values:
|
||
|
|
1 - edge triggered on the rising edge.
|
||
|
|
2 - edge triggered on the falling edge
|
||
|
|
4 - level triggered active high.
|
||
|
|
8 - level triggered active low.
|
||
|
|
|
||
|
|
- interrupts: Interrupt routing for each pin.
|
||
|
|
|
||
|
|
Example:
|
||
|
|
|
||
|
|
gpio-controller@1070000000800 {
|
||
|
|
#gpio-cells = <2>;
|
||
|
|
compatible = "cavium,octeon-3860-gpio";
|
||
|
|
reg = <0x10700 0x00000800 0x0 0x100>;
|
||
|
|
gpio-controller;
|
||
|
|
/* Interrupts are specified by two parts:
|
||
|
|
* 1) GPIO pin number (0..15)
|
||
|
|
* 2) Triggering (1 - edge rising
|
||
|
|
* 2 - edge falling
|
||
|
|
* 4 - level active high
|
||
|
|
* 8 - level active low)
|
||
|
|
*/
|
||
|
|
interrupt-controller;
|
||
|
|
#interrupt-cells = <2>;
|
||
|
|
/* The GPIO pin connect to 16 consecutive CUI bits */
|
||
|
|
interrupts = <0 16>, <0 17>, <0 18>, <0 19>,
|
||
|
|
<0 20>, <0 21>, <0 22>, <0 23>,
|
||
|
|
<0 24>, <0 25>, <0 26>, <0 27>,
|
||
|
|
<0 28>, <0 29>, <0 30>, <0 31>;
|
||
|
|
};
|