linux/drivers/net/wireless/ath/ath9k/debug.h

336 lines
8.5 KiB
C
Raw Normal View History

/*
* Copyright (c) 2008-2011 Atheros Communications Inc.
*
* Permission to use, copy, modify, and/or distribute this software for any
* purpose with or without fee is hereby granted, provided that the above
* copyright notice and this permission notice appear in all copies.
*
* THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES
* WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF
* MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR
* ANY SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES
* WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN
* ACTION OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF
* OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE.
*/
#ifndef DEBUG_H
#define DEBUG_H
#include "hw.h"
#include "rc.h"
#include "dfs_debug.h"
struct ath_txq;
struct ath_buf;
#ifdef CONFIG_ATH9K_DEBUGFS
#define TX_STAT_INC(q, c) sc->debug.stats.txstats[q].c++
#define RESET_STAT_INC(sc, type) sc->debug.stats.reset[type]++
#else
#define TX_STAT_INC(q, c) do { } while (0)
#define RESET_STAT_INC(sc, type) do { } while (0)
#endif
enum ath_reset_type {
RESET_TYPE_BB_HANG,
RESET_TYPE_BB_WATCHDOG,
RESET_TYPE_FATAL_INT,
RESET_TYPE_TX_ERROR,
RESET_TYPE_TX_HANG,
RESET_TYPE_PLL_HANG,
RESET_TYPE_MAC_HANG,
RESET_TYPE_BEACON_STUCK,
RESET_TYPE_MCI,
__RESET_TYPE_MAX
};
#ifdef CONFIG_ATH9K_DEBUGFS
/**
* struct ath_interrupt_stats - Contains statistics about interrupts
* @total: Total no. of interrupts generated so far
* @rxok: RX with no errors
* @rxlp: RX with low priority RX
* @rxhp: RX with high priority, uapsd only
* @rxeol: RX with no more RXDESC available
* @rxorn: RX FIFO overrun
* @txok: TX completed at the requested rate
* @txurn: TX FIFO underrun
* @mib: MIB regs reaching its threshold
* @rxphyerr: RX with phy errors
* @rx_keycache_miss: RX with key cache misses
* @swba: Software Beacon Alert
* @bmiss: Beacon Miss
* @bnr: Beacon Not Ready
* @cst: Carrier Sense TImeout
* @gtt: Global TX Timeout
* @tim: RX beacon TIM occurrence
* @cabend: RX End of CAB traffic
* @dtimsync: DTIM sync lossage
* @dtim: RX Beacon with DTIM
* @bb_watchdog: Baseband watchdog
* @tsfoor: TSF out of range, indicates that the corrected TSF received
* from a beacon differs from the PCU's internal TSF by more than a
* (programmable) threshold
* @local_timeout: Internal bus timeout.
*/
struct ath_interrupt_stats {
u32 total;
u32 rxok;
u32 rxlp;
u32 rxhp;
u32 rxeol;
u32 rxorn;
u32 txok;
u32 txeol;
u32 txurn;
u32 mib;
u32 rxphyerr;
u32 rx_keycache_miss;
u32 swba;
u32 bmiss;
u32 bnr;
u32 cst;
u32 gtt;
u32 tim;
u32 cabend;
u32 dtimsync;
u32 dtim;
u32 bb_watchdog;
u32 tsfoor;
u32 mci;
/* Sync-cause stats */
u32 sync_cause_all;
u32 sync_rtc_irq;
u32 sync_mac_irq;
u32 eeprom_illegal_access;
u32 apb_timeout;
u32 pci_mode_conflict;
u32 host1_fatal;
u32 host1_perr;
u32 trcv_fifo_perr;
u32 radm_cpl_ep;
u32 radm_cpl_dllp_abort;
u32 radm_cpl_tlp_abort;
u32 radm_cpl_ecrc_err;
u32 radm_cpl_timeout;
u32 local_timeout;
u32 pm_access;
u32 mac_awake;
u32 mac_asleep;
u32 mac_sleep_access;
};
/**
* struct ath_tx_stats - Statistics about TX
* @tx_pkts_all: No. of total frames transmitted, including ones that
may have had errors.
* @tx_bytes_all: No. of total bytes transmitted, including ones that
may have had errors.
* @queued: Total MPDUs (non-aggr) queued
* @completed: Total MPDUs (non-aggr) completed
* @a_aggr: Total no. of aggregates queued
* @a_queued_hw: Total AMPDUs queued to hardware
* @a_queued_sw: Total AMPDUs queued to software queues
* @a_completed: Total AMPDUs completed
* @a_retries: No. of AMPDUs retried (SW)
* @a_xretries: No. of AMPDUs dropped due to xretries
* @fifo_underrun: FIFO underrun occurrences
Valid only for:
- non-aggregate condition.
- first packet of aggregate.
* @xtxop: No. of frames filtered because of TXOP limit
* @timer_exp: Transmit timer expiry
* @desc_cfg_err: Descriptor configuration errors
* @data_urn: TX data underrun errors
* @delim_urn: TX delimiter underrun errors
* @puttxbuf: Number of times hardware was given txbuf to write.
* @txstart: Number of times hardware was told to start tx.
* @txprocdesc: Number of times tx descriptor was processed
* @txfailed: Out-of-memory or other errors in xmit path.
*/
struct ath_tx_stats {
u32 tx_pkts_all;
u32 tx_bytes_all;
u32 queued;
u32 completed;
u32 xretries;
u32 a_aggr;
u32 a_queued_hw;
u32 a_queued_sw;
u32 a_completed;
u32 a_retries;
u32 a_xretries;
u32 fifo_underrun;
u32 xtxop;
u32 timer_exp;
u32 desc_cfg_err;
u32 data_underrun;
u32 delim_underrun;
u32 puttxbuf;
u32 txstart;
u32 txprocdesc;
u32 txfailed;
};
#define RX_STAT_INC(c) (sc->debug.stats.rxstats.c++)
/**
* struct ath_rx_stats - RX Statistics
* @rx_pkts_all: No. of total frames received, including ones that
may have had errors.
* @rx_bytes_all: No. of total bytes received, including ones that
may have had errors.
* @crc_err: No. of frames with incorrect CRC value
* @decrypt_crc_err: No. of frames whose CRC check failed after
decryption process completed
* @phy_err: No. of frames whose reception failed because the PHY
encountered an error
* @mic_err: No. of frames with incorrect TKIP MIC verification failure
* @pre_delim_crc_err: Pre-Frame delimiter CRC error detections
* @post_delim_crc_err: Post-Frame delimiter CRC error detections
* @decrypt_busy_err: Decryption interruptions counter
* @phy_err_stats: Individual PHY error statistics
* @rx_len_err: No. of frames discarded due to bad length.
* @rx_oom_err: No. of frames dropped due to OOM issues.
* @rx_rate_err: No. of frames dropped due to rate errors.
* @rx_too_many_frags_err: Frames dropped due to too-many-frags received.
* @rx_drop_rxflush: No. of frames dropped due to RX-FLUSH.
* @rx_beacons: No. of beacons received.
* @rx_frags: No. of rx-fragements received.
*/
struct ath_rx_stats {
u32 rx_pkts_all;
u32 rx_bytes_all;
u32 crc_err;
u32 decrypt_crc_err;
u32 phy_err;
u32 mic_err;
u32 pre_delim_crc_err;
u32 post_delim_crc_err;
u32 decrypt_busy_err;
u32 phy_err_stats[ATH9K_PHYERR_MAX];
u32 rx_len_err;
u32 rx_oom_err;
u32 rx_rate_err;
u32 rx_too_many_frags_err;
u32 rx_drop_rxflush;
u32 rx_beacons;
u32 rx_frags;
};
struct ath_stats {
struct ath_interrupt_stats istats;
struct ath_tx_stats txstats[ATH9K_NUM_TX_QUEUES];
struct ath_rx_stats rxstats;
struct ath_dfs_stats dfs_stats;
u32 reset[__RESET_TYPE_MAX];
};
#define ATH_DBG_MAX_SAMPLES 10
struct ath_dbg_bb_mac_samp {
u32 dma_dbg_reg_vals[ATH9K_NUM_DMA_DEBUG_REGS];
u32 pcu_obs, pcu_cr, noise;
struct {
u64 jiffies;
int8_t rssi_ctl0;
int8_t rssi_ctl1;
int8_t rssi_ctl2;
int8_t rssi_ext0;
int8_t rssi_ext1;
int8_t rssi_ext2;
int8_t rssi;
bool isok;
u8 rts_fail_cnt;
u8 data_fail_cnt;
u8 rateindex;
u8 qid;
u8 tid;
u32 ba_low;
u32 ba_high;
} ts[ATH_DBG_MAX_SAMPLES];
struct {
u64 jiffies;
int8_t rssi_ctl0;
int8_t rssi_ctl1;
int8_t rssi_ctl2;
int8_t rssi_ext0;
int8_t rssi_ext1;
int8_t rssi_ext2;
int8_t rssi;
bool is_mybeacon;
u8 antenna;
u8 rate;
} rs[ATH_DBG_MAX_SAMPLES];
struct ath_cycle_counters cc;
struct ath9k_nfcal_hist nfCalHist[NUM_NF_READINGS];
};
struct ath9k_debug {
struct dentry *debugfs_phy;
u32 regidx;
struct ath_stats stats;
#ifdef CONFIG_ATH9K_MAC_DEBUG
spinlock_t samp_lock;
struct ath_dbg_bb_mac_samp bb_mac_samp[ATH_DBG_MAX_SAMPLES];
u8 sampidx;
u8 tsidx;
u8 rsidx;
#endif
};
int ath9k_init_debug(struct ath_hw *ah);
void ath_debug_stat_interrupt(struct ath_softc *sc, enum ath9k_int status);
ath9k: rework tx queue selection and fix queue stopping/waking The current ath9k tx queue handling code showed a few issues that could lead to locking issues, tx stalls due to stopped queues, and maybe even DMA issues. The main source of these issues is that in some places the queue is selected via skb queue mapping in places where this mapping may no longer be valid. One such place is when data frames are transmitted via the CAB queue (for powersave buffered frames). This is made even worse by a lookup WMM AC values from the assigned tx queue (which is undefined for the CAB queue). This messed up the pending frame counting, which in turn caused issues with queues getting stopped, but not woken again. To fix these issues, this patch removes an unnecessary abstraction separating a driver internal queue number from the skb queue number (not to be confused with the hardware queue number). It seems that this abstraction may have been necessary because of tx queue preinitialization from the initvals. This patch avoids breakage here by pushing the software <-> hardware queue mapping to the function that assigns the tx queues and redefining the WMM AC definitions to match the numbers used by mac80211 (also affects ath9k_htc). To ensure consistency wrt. pending frame count tracking, these counters are moved to the ath_txq struct, updated with the txq lock held, but only where the tx queue selected by the skb queue map actually matches the tx queue used by the driver for the frame. Signed-off-by: Felix Fietkau <nbd@openwrt.org> Reported-by: Björn Smedman <bjorn.smedman@venatech.se> Signed-off-by: John W. Linville <linville@tuxdriver.com>
2010-11-07 21:59:39 +08:00
void ath_debug_stat_tx(struct ath_softc *sc, struct ath_buf *bf,
struct ath_tx_status *ts, struct ath_txq *txq,
unsigned int flags);
void ath_debug_stat_rx(struct ath_softc *sc, struct ath_rx_status *rs);
#else
#define RX_STAT_INC(c) /* NOP */
static inline int ath9k_init_debug(struct ath_hw *ah)
{
return 0;
}
static inline void ath_debug_stat_interrupt(struct ath_softc *sc,
enum ath9k_int status)
{
}
static inline void ath_debug_stat_tx(struct ath_softc *sc,
struct ath_buf *bf,
struct ath_tx_status *ts,
struct ath_txq *txq,
unsigned int flags)
{
}
static inline void ath_debug_stat_rx(struct ath_softc *sc,
struct ath_rx_status *rs)
{
}
#endif /* CONFIG_ATH9K_DEBUGFS */
#ifdef CONFIG_ATH9K_MAC_DEBUG
void ath9k_debug_samp_bb_mac(struct ath_softc *sc);
#else
static inline void ath9k_debug_samp_bb_mac(struct ath_softc *sc)
{
}
#endif
#endif /* DEBUG_H */