mirror of https://gitee.com/openkylin/linux.git
22 lines
729 B
Plaintext
22 lines
729 B
Plaintext
|
Lattice iCE40 FPGA Manager
|
||
|
|
|
||
|
|
Required properties:
|
||
|
|
- compatible: Should contain "lattice,ice40-fpga-mgr"
|
||
|
|
- reg: SPI chip select
|
||
|
|
- spi-max-frequency: Maximum SPI frequency (>=1000000, <=25000000)
|
||
|
|
- cdone-gpios: GPIO input connected to CDONE pin
|
||
|
|
- reset-gpios: Active-low GPIO output connected to CRESET_B pin. Note
|
||
|
|
that unless the GPIO is held low during startup, the
|
||
|
|
FPGA will enter Master SPI mode and drive SCK with a
|
||
|
|
clock signal potentially jamming other devices on the
|
||
|
|
bus until the firmware is loaded.
|
||
|
|
|
||
|
|
Example:
|
||
|
|
fpga: fpga@0 {
|
||
|
|
compatible = "lattice,ice40-fpga-mgr";
|
||
|
|
reg = <0>;
|
||
|
|
spi-max-frequency = <1000000>;
|
||
|
|
cdone-gpios = <&gpio 24 GPIO_ACTIVE_HIGH>;
|
||
|
|
reset-gpios = <&gpio 22 GPIO_ACTIVE_LOW>;
|
||
|
|
};
|