From 0954e1c258c4018bfd370da41fbb5deb34582976 Mon Sep 17 00:00:00 2001 From: Anton Vorontsov Date: Fri, 7 May 2010 01:09:19 +0400 Subject: [PATCH] USB: isp1760: Soften DW3 X/transaction error bit handling There were some reports[1] of isp1760 USB driver malfunctioning with high speed devices, noticed on Blackfin and PowerPC targets. These reports indicated that the original Philips 'pehcd'[2] driver worked fine. We've noticed the same issue with an ARM RealView platform. This happens under load (with only some mass storage devices, not all, just as in another report[3]): error bit is set in DW3 error bit is set in DW3 error bit is set in DW3 usb 1-1.2: device descriptor read/64, error -32 It appears that the 'pehcd' driver checks the X bit only if the transaction is halted (H bit), otherwise the error is so far insignificant. The ISP176x chips were modeled after EHCI, and EHCI spec says (thanks to Alan Stern for pointing out): "Transaction errors cause the status field to be updated to reflect the type of error, but the transaction continues to be retried until the Active bit is set to 0. When the error counter reaches 0, the Halt bit is set and the Active bit is cleared." So, just as the original Philips driver, isp1760 must report the error only if the transaction error and the halt bits are set. [1] http://markmail.org/message/lx4qrlbrs2uhcnly [2] svn co svn://sources.blackfin.uclinux.org/linux-kernel/trunk/drivers/usb/host -r 5494 See pehci.c:pehci_hcd_update_error_status(). [3] http://blackfin.uclinux.org/gf/tracker/5148 Signed-off-by: Anton Vorontsov Acked-by: Sebastian Andrzej Siewior Signed-off-by: Greg Kroah-Hartman --- drivers/usb/host/isp1760-hcd.c | 7 +++---- 1 file changed, 3 insertions(+), 4 deletions(-) diff --git a/drivers/usb/host/isp1760-hcd.c b/drivers/usb/host/isp1760-hcd.c index 13f7d1200bc0..dbcafa29c775 100644 --- a/drivers/usb/host/isp1760-hcd.c +++ b/drivers/usb/host/isp1760-hcd.c @@ -713,12 +713,11 @@ static int check_error(struct ptd *ptd) u32 dw3; dw3 = le32_to_cpu(ptd->dw3); - if (dw3 & DW3_HALT_BIT) + if (dw3 & DW3_HALT_BIT) { error = -EPIPE; - if (dw3 & DW3_ERROR_BIT) { - printk(KERN_ERR "error bit is set in DW3\n"); - error = -EPIPE; + if (dw3 & DW3_ERROR_BIT) + pr_err("error bit is set in DW3\n"); } if (dw3 & DW3_QTD_ACTIVE) {