From 410a494902777c11f95031d9ed757d7f8f09c5c6 Mon Sep 17 00:00:00 2001 From: Emil Tantilov Date: Wed, 17 May 2017 15:17:46 -0700 Subject: [PATCH] ixgbe: add write flush when configuring CS4223/7 Make sure the writes are processed immediately. Without the flush it is possible for operations on one port to spill over the other as the resource is shared. Signed-off-by: Emil Tantilov Tested-by: Andrew Bowers Signed-off-by: Jeff Kirsher --- drivers/net/ethernet/intel/ixgbe/ixgbe_x550.c | 20 +++++++++++++++++-- 1 file changed, 18 insertions(+), 2 deletions(-) diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_x550.c b/drivers/net/ethernet/intel/ixgbe/ixgbe_x550.c index 32b35efde2df..80824fec15d2 100644 --- a/drivers/net/ethernet/intel/ixgbe/ixgbe_x550.c +++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_x550.c @@ -1824,12 +1824,28 @@ ixgbe_setup_mac_link_sfp_x550a(struct ixgbe_hw *hw, ixgbe_link_speed speed, /* Configure CS4227/CS4223 LINE side to proper mode. */ reg_slice = IXGBE_CS4227_LINE_SPARE24_LSB + slice_offset; + + ret_val = hw->phy.ops.read_reg(hw, reg_slice, + IXGBE_MDIO_ZERO_DEV_TYPE, ®_phy_ext); + if (ret_val) + return ret_val; + + reg_phy_ext &= ~((IXGBE_CS4227_EDC_MODE_CX1 << 1) | + (IXGBE_CS4227_EDC_MODE_SR << 1)); + if (setup_linear) reg_phy_ext = (IXGBE_CS4227_EDC_MODE_CX1 << 1) | 1; else reg_phy_ext = (IXGBE_CS4227_EDC_MODE_SR << 1) | 1; - return hw->phy.ops.write_reg(hw, reg_slice, IXGBE_MDIO_ZERO_DEV_TYPE, - reg_phy_ext); + + ret_val = hw->phy.ops.write_reg(hw, reg_slice, + IXGBE_MDIO_ZERO_DEV_TYPE, reg_phy_ext); + if (ret_val) + return ret_val; + + /* Flush previous write with a read */ + return hw->phy.ops.read_reg(hw, reg_slice, + IXGBE_MDIO_ZERO_DEV_TYPE, ®_phy_ext); } /**