Merge remote-tracking branches 'spi/fix/fsl-dspi', 'spi/fix/fsl-espi', 'spi/fix/orion' and 'spi/fix/pl022' into spi-linus

Documentation/devicetree/bindings/spi/spi_pl022.txt

@@ -4,9 +4,9 @@ Required properties:
 - compatible : "arm,pl022", "arm,primecell"
 - reg : Offset and length of the register set for the device
 - interrupts : Should contain SPI controller interrupt
+- num-cs : total number of chipselects
 
 Optional properties:
-- num-cs : total number of chipselects
 - cs-gpios : should specify GPIOs used for chipselects.
   The gpios will be referred to as reg = <index> in the SPI child nodes.
   If unspecified, a single SPI device without a chip select can be used.

drivers/spi/spi-fsl-dspi.c

@@ -341,10 +341,10 @@ static int dspi_transfer_one_message(struct spi_master *master,
 		dspi->cur_msg = message;
 		dspi->cur_chip = spi_get_ctldata(spi);
 		dspi->cs = spi->chip_select;
+		dspi->cs_change = 0;
 		if (dspi->cur_transfer->transfer_list.next
 				== &dspi->cur_msg->transfers)
-			transfer->cs_change = 1;
-		dspi->cs_change = transfer->cs_change;
+			dspi->cs_change = 1;
 		dspi->void_write_data = dspi->cur_chip->void_write_data;
 
 		dspi->dataflags = 0;

drivers/spi/spi-fsl-espi.c

@@ -561,9 +561,13 @@ void fsl_espi_cpu_irq(struct mpc8xxx_spi *mspi, u32 events)
 
 		/* spin until TX is done */
 		ret = spin_event_timeout(((events = mpc8xxx_spi_read_reg(
-				&reg_base->event)) & SPIE_NF) == 0, 1000, 0);
+				&reg_base->event)) & SPIE_NF), 1000, 0);
 		if (!ret) {
 			dev_err(mspi->dev, "tired waiting for SPIE_NF\n");
+
+			/* Clear the SPIE bits */
+			mpc8xxx_spi_write_reg(&reg_base->event, events);
+			complete(&mspi->done);
 			return;
 		}
 	}

drivers/spi/spi-orion.c

@@ -61,6 +61,12 @@ enum orion_spi_type {
 
 struct orion_spi_dev {
 	enum orion_spi_type	typ;
+	/*
+	 * min_divisor and max_hz should be exclusive, the only we can
+	 * have both is for managing the armada-370-spi case with old
+	 * device tree
+	 */
+	unsigned long		max_hz;
 	unsigned int		min_divisor;
 	unsigned int		max_divisor;
 	u32			prescale_mask;
@@ -387,8 +393,9 @@ static const struct orion_spi_dev orion_spi_dev_data = {
 
 static const struct orion_spi_dev armada_spi_dev_data = {
 	.typ = ARMADA_SPI,
-	.min_divisor = 1,
+	.min_divisor = 4,
 	.max_divisor = 1920,
+	.max_hz = 50000000,
 	.prescale_mask = ARMADA_SPI_CLK_PRESCALE_MASK,
 };
 
@@ -454,7 +461,21 @@ static int orion_spi_probe(struct platform_device *pdev)
 		goto out;
 
 	tclk_hz = clk_get_rate(spi->clk);
-	master->max_speed_hz = DIV_ROUND_UP(tclk_hz, devdata->min_divisor);
+
+	/*
+	 * With old device tree, armada-370-spi could be used with
+	 * Armada XP, however for this SoC the maximum frequency is
+	 * 50MHz instead of tclk/4. On Armada 370, tclk cannot be
+	 * higher than 200MHz. So, in order to be able to handle both
+	 * SoCs, we can take the minimum of 50MHz and tclk/4.
+	 */
+	if (of_device_is_compatible(pdev->dev.of_node,
+					"marvell,armada-370-spi"))
+		master->max_speed_hz = min(devdata->max_hz,
+				DIV_ROUND_UP(tclk_hz, devdata->min_divisor));
+	else
+		master->max_speed_hz =
+			DIV_ROUND_UP(tclk_hz, devdata->min_divisor);
 	master->min_speed_hz = DIV_ROUND_UP(tclk_hz, devdata->max_divisor);
 
 	r = platform_get_resource(pdev, IORESOURCE_MEM, 0);