mirror of https://gitee.com/openkylin/linux.git
drm/i915: Parametrize the dphy and other spec specific parameters
The values of these parameters will be different for differnet panel based on dsi rate, lane count, etc. Remove the hardcodings and make these as parameters whch will be initialized in panel specific sub-encoder implementaion. This will also form groundwork for planned generic panel sub-encoder implemntation based on VBT design enhancments to support multiple panels v2: Mask away the port_bits before use Signed-off-by: Shobhit Kumar <shobhit.kumar@intel.com> Reviewed-by: Jani Nikula <jani.nikula@intel.com> Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
This commit is contained in:
parent
a4a593be5d
commit
f6da28429a
|
@ -157,7 +157,8 @@ static void intel_dsi_enable(struct intel_encoder *encoder)
|
|||
msleep(100);
|
||||
|
||||
/* assert ip_tg_enable signal */
|
||||
temp = I915_READ(MIPI_PORT_CTRL(pipe));
|
||||
temp = I915_READ(MIPI_PORT_CTRL(pipe)) & ~LANE_CONFIGURATION_MASK;
|
||||
temp = temp | intel_dsi->port_bits;
|
||||
I915_WRITE(MIPI_PORT_CTRL(pipe), temp | DPI_ENABLE);
|
||||
POSTING_READ(MIPI_PORT_CTRL(pipe));
|
||||
}
|
||||
|
@ -391,11 +392,7 @@ static void intel_dsi_mode_set(struct intel_encoder *intel_encoder)
|
|||
I915_WRITE(MIPI_INTR_STAT(pipe), 0xffffffff);
|
||||
I915_WRITE(MIPI_INTR_EN(pipe), 0xffffffff);
|
||||
|
||||
I915_WRITE(MIPI_DPHY_PARAM(pipe),
|
||||
0x3c << EXIT_ZERO_COUNT_SHIFT |
|
||||
0x1f << TRAIL_COUNT_SHIFT |
|
||||
0xc5 << CLK_ZERO_COUNT_SHIFT |
|
||||
0x1f << PREPARE_COUNT_SHIFT);
|
||||
I915_WRITE(MIPI_DPHY_PARAM(pipe), intel_dsi->dphy_reg);
|
||||
|
||||
I915_WRITE(MIPI_DPI_RESOLUTION(pipe),
|
||||
adjusted_mode->vdisplay << VERTICAL_ADDRESS_SHIFT |
|
||||
|
@ -443,9 +440,9 @@ static void intel_dsi_mode_set(struct intel_encoder *intel_encoder)
|
|||
adjusted_mode->htotal,
|
||||
bpp, intel_dsi->lane_count) + 1);
|
||||
}
|
||||
I915_WRITE(MIPI_LP_RX_TIMEOUT(pipe), 8309); /* max */
|
||||
I915_WRITE(MIPI_TURN_AROUND_TIMEOUT(pipe), 0x14); /* max */
|
||||
I915_WRITE(MIPI_DEVICE_RESET_TIMER(pipe), 0xffff); /* max */
|
||||
I915_WRITE(MIPI_LP_RX_TIMEOUT(pipe), intel_dsi->lp_rx_timeout);
|
||||
I915_WRITE(MIPI_TURN_AROUND_TIMEOUT(pipe), intel_dsi->turn_arnd_val);
|
||||
I915_WRITE(MIPI_DEVICE_RESET_TIMER(pipe), intel_dsi->rst_timer_val);
|
||||
|
||||
/* dphy stuff */
|
||||
|
||||
|
@ -460,29 +457,31 @@ static void intel_dsi_mode_set(struct intel_encoder *intel_encoder)
|
|||
*
|
||||
* XXX: write MIPI_STOP_STATE_STALL?
|
||||
*/
|
||||
I915_WRITE(MIPI_HIGH_LOW_SWITCH_COUNT(pipe), 0x46);
|
||||
I915_WRITE(MIPI_HIGH_LOW_SWITCH_COUNT(pipe),
|
||||
intel_dsi->hs_to_lp_count);
|
||||
|
||||
/* XXX: low power clock equivalence in terms of byte clock. the number
|
||||
* of byte clocks occupied in one low power clock. based on txbyteclkhs
|
||||
* and txclkesc. txclkesc time / txbyteclk time * (105 +
|
||||
* MIPI_STOP_STATE_STALL) / 105.???
|
||||
*/
|
||||
I915_WRITE(MIPI_LP_BYTECLK(pipe), 4);
|
||||
I915_WRITE(MIPI_LP_BYTECLK(pipe), intel_dsi->lp_byte_clk);
|
||||
|
||||
/* the bw essential for transmitting 16 long packets containing 252
|
||||
* bytes meant for dcs write memory command is programmed in this
|
||||
* register in terms of byte clocks. based on dsi transfer rate and the
|
||||
* number of lanes configured the time taken to transmit 16 long packets
|
||||
* in a dsi stream varies. */
|
||||
I915_WRITE(MIPI_DBI_BW_CTRL(pipe), 0x820);
|
||||
I915_WRITE(MIPI_DBI_BW_CTRL(pipe), intel_dsi->bw_timer);
|
||||
|
||||
I915_WRITE(MIPI_CLK_LANE_SWITCH_TIME_CNT(pipe),
|
||||
0xa << LP_HS_SSW_CNT_SHIFT |
|
||||
0x14 << HS_LP_PWR_SW_CNT_SHIFT);
|
||||
intel_dsi->clk_lp_to_hs_count << LP_HS_SSW_CNT_SHIFT |
|
||||
intel_dsi->clk_hs_to_lp_count << HS_LP_PWR_SW_CNT_SHIFT);
|
||||
|
||||
if (is_vid_mode(intel_dsi))
|
||||
I915_WRITE(MIPI_VIDEO_MODE_FORMAT(pipe),
|
||||
intel_dsi->video_mode_format);
|
||||
intel_dsi->video_frmt_cfg_bits |
|
||||
intel_dsi->video_mode_format);
|
||||
}
|
||||
|
||||
static enum drm_connector_status
|
||||
|
|
|
@ -96,6 +96,20 @@ struct intel_dsi {
|
|||
|
||||
/* eot for MIPI_EOT_DISABLE register */
|
||||
u32 eot_disable;
|
||||
|
||||
u32 port_bits;
|
||||
u32 bw_timer;
|
||||
u32 dphy_reg;
|
||||
u32 video_frmt_cfg_bits;
|
||||
u16 lp_byte_clk;
|
||||
|
||||
/* timeouts in byte clocks */
|
||||
u16 lp_rx_timeout;
|
||||
u16 turn_arnd_val;
|
||||
u16 rst_timer_val;
|
||||
u16 hs_to_lp_count;
|
||||
u16 clk_lp_to_hs_count;
|
||||
u16 clk_hs_to_lp_count;
|
||||
};
|
||||
|
||||
static inline struct intel_dsi *enc_to_intel_dsi(struct drm_encoder *encoder)
|
||||
|
|
Loading…
Reference in New Issue