Device 'new_id' interface is useful for testing of not yet published
hardware on older kernels and for internally used device ids on
simulation platforms.
However currently with the device configuration held in device_id driver
data as a pointer to mei_cfg structure it is hard, as one need to locate
the address of the correct structure.
A recommended way of doing that is to use and index instead of a
pointer.
This patch adds a new list of configuration mei_cfg_list[]
indexed via enum mei_cfg_idx.
In addition it cleanups ich platform naming, renames legacy
generation to ich and what was ich to ich10.
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Alexander Usyskin <alexander.usyskin@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Since the newer HW sports two interrupts causes we cannot
just simply acknowledge the interrupts directly in the quick handler
and store the cause in the member variable, as the cause
will be overridden upon next interrupt while the interrupt thread
was not yet scheduled handling the previous interrupt.
The simple fix is to disable interrupts in quick handler
and acknowledge and enabled them in the interrupt thread.
Signed-off-by: Alexander Usyskin <alexander.usyskin@intel.com>
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
D0i3 adds additional interrupt reason bit, therefore we add a variable
intr_source to save the interrupt causes for further dispatching.
The interrupt cause is saved in the irq quick handler to achieve
unified behavior for both MSI enabled and shared interrupt platforms.
Signed-off-by: Alexander Usyskin <alexander.usyskin@intel.com>
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Detect d0i3 low power state during hw configuration,
the value is set in HFS_1 pci config reigister.
Signed-off-by: Alexander Usyskin <alexander.usyskin@intel.com>
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
The current power gating naming was confusing,
we wish to swap meanings of register and flow level power gating terms,
For registers writing level use terms set and unset:
mei_me_pg_set, mei_me_pg_unset
For flow/high level use power gating enter and power gating exit terms
mei_me_pg_enter_sync, mei_me_pg_exit_sync
Signed-off-by: Alexander Usyskin <alexander.usyskin@intel.com>
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
ME devices prior to PCH8 (Lynx Point) have two FW status registers,
on PCH8 and newer excluding txe there are six FW status registers.
Signed-off-by: Alexander Usyskin <alexander.usyskin@intel.com>
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Kill host_hw_status and me_hw_state from me hw structure that used
to cache host and me csr values.
We do not use the cached values across the function calls anymore
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Alexander Usyskin <alexander.usyskin@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Device specific configurations are currently only needed by me hw
so we can remove it from txe
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Move quirk FW type detector to cfg structure
Signed-off-by: Alexander Usyskin <alexander.usyskin@intel.com>
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Add mei_cfg structure that holds per device configuration
data and hooks, as the first step we add firmware
status register offsets
Signed-off-by: Alexander Usyskin <alexander.usyskin@intel.com>
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Add runtime pm framework for ME devices.
The runtime pm handlers are used to run
me power gating isolation protocol
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Alexander Usyskin <alexander.usyskin@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
For power gating entry we write hbm pg entry request command and
then we set pg register
For power gating exit we clear pg register and wait for exit request
hbm command.
Exit power gating request might also be initiated by the firmware
w/o explicit driver request
The power gating state is tracked by pg_state member of me_hw
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Alexander Usyskin <alexander.usyskin@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
We currently include <linux/irqreturn.h> in <linux/pci.h>, but I'm about to
remove that from linux/pci.h, so add explicit includes where needed.
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Acked-by: Tomas Winkler <tomas.winkler@intel.com>
1. Move the mei_data2slots to mei_dev.h as it will be used
by the all supported HW.
2. Change return value from u8 to u32 to catch possible overflows
3. Eliminate computing the slots number twice in the same function
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
interrupt handler are platform specifics so we move
them to hw-mei.c. For sake of that we need to export
write, read, and complete handlers from the interrupt.c
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
We add struct mei_hw_ops to virtualize access to hw specific
configurations. This allows us to separate the compilation
of the ME interface from the ME hardware specifics
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
This is initial step of move the ME hw specifics
out of mei_device structure into mei_me_hw
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Rename hw-me.h to hw-me-regs.h as this file
contains only register definitions.
Files hw-me.[ch] now contains ME hw dependant
functionality
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Tomas Winkler