mirror of https://gitee.com/openkylin/linux.git
56 lines
1.4 KiB
Plaintext
56 lines
1.4 KiB
Plaintext
Toshiba et8ek8 5MP sensor
|
|
|
|
Toshiba et8ek8 5MP sensor is an image sensor found in Nokia N900 device
|
|
|
|
More detailed documentation can be found in
|
|
Documentation/devicetree/bindings/media/video-interfaces.txt .
|
|
|
|
|
|
Mandatory properties
|
|
--------------------
|
|
|
|
- compatible: "toshiba,et8ek8"
|
|
- reg: I2C address (0x3e, or an alternative address)
|
|
- vana-supply: Analogue voltage supply (VANA), 2.8 volts
|
|
- clocks: External clock to the sensor
|
|
- clock-frequency: Frequency of the external clock to the sensor. Camera
|
|
driver will set this frequency on the external clock. The clock frequency is
|
|
a pre-determined frequency known to be suitable to the board.
|
|
- reset-gpios: XSHUTDOWN GPIO. The XSHUTDOWN signal is active low. The sensor
|
|
is in hardware standby mode when the signal is in the low state.
|
|
|
|
|
|
Optional properties
|
|
-------------------
|
|
|
|
- flash-leds: See ../video-interfaces.txt
|
|
- lens-focus: See ../video-interfaces.txt
|
|
|
|
|
|
Endpoint node mandatory properties
|
|
----------------------------------
|
|
|
|
- remote-endpoint: A phandle to the bus receiver's endpoint node.
|
|
|
|
|
|
Example
|
|
-------
|
|
|
|
&i2c3 {
|
|
clock-frequency = <400000>;
|
|
|
|
cam1: camera@3e {
|
|
compatible = "toshiba,et8ek8";
|
|
reg = <0x3e>;
|
|
vana-supply = <&vaux4>;
|
|
clocks = <&isp 0>;
|
|
clock-frequency = <9600000>;
|
|
reset-gpio = <&gpio4 6 GPIO_ACTIVE_HIGH>; /* 102 */
|
|
port {
|
|
csi_cam1: endpoint {
|
|
remote-endpoint = <&csi_out1>;
|
|
};
|
|
};
|
|
};
|
|
};
|