mirror of https://gitee.com/openkylin/linux.git
c15f8ba6dc
The F54 Report Data is apparently read through a fifo and for the smbus protocol that means that between reading a block of 32 bytes the rmiaddr shouldn't be incremented. However, changing that causes other non-fifo reads to fail and so that change was reverted. This patch changes just the F54 function and it now reads 32 bytes at a time from the fifo, using the F54_FIFO_OFFSET to update the start address that is used when reading from the fifo. This has only been tested with smbus, not with i2c or spi. But I suspect that the same is needed there since I think similar problems will occur there when reading more than 256 bytes. Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl> Tested-by: Hans Verkuil <hverkuil-cisco@xs4all.nl> Reported-by: Timo Kaufmann <timokau@zoho.com> Link: https://lore.kernel.org/r/20200115124819.3191024-3-hverkuil-cisco@xs4all.nl Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com> |
||
|---|---|---|
| .. | ||
| Kconfig | ||
| Makefile | ||
| rmi_2d_sensor.c | ||
| rmi_2d_sensor.h | ||
| rmi_bus.c | ||
| rmi_bus.h | ||
| rmi_driver.c | ||
| rmi_driver.h | ||
| rmi_f01.c | ||
| rmi_f03.c | ||
| rmi_f11.c | ||
| rmi_f12.c | ||
| rmi_f30.c | ||
| rmi_f34.c | ||
| rmi_f34.h | ||
| rmi_f34v7.c | ||
| rmi_f54.c | ||
| rmi_f55.c | ||
| rmi_i2c.c | ||
| rmi_smbus.c | ||
| rmi_spi.c | ||