mirror of https://gitee.com/openkylin/linux.git
59 lines
1.8 KiB
Plaintext
59 lines
1.8 KiB
Plaintext
Socionext UniPhier Regulator Controller
|
|
|
|
This describes the devicetree bindings for regulator controller implemented
|
|
on Socionext UniPhier SoCs.
|
|
|
|
USB3 Controller
|
|
---------------
|
|
|
|
This regulator controls VBUS and belongs to USB3 glue layer. Before using
|
|
the regulator, it is necessary to control the clocks and resets to enable
|
|
this layer. These clocks and resets should be described in each property.
|
|
|
|
Required properties:
|
|
- compatible: Should be
|
|
"socionext,uniphier-pro4-usb3-regulator" - for Pro4 SoC
|
|
"socionext,uniphier-pro5-usb3-regulator" - for Pro5 SoC
|
|
"socionext,uniphier-pxs2-usb3-regulator" - for PXs2 SoC
|
|
"socionext,uniphier-ld20-usb3-regulator" - for LD20 SoC
|
|
"socionext,uniphier-pxs3-usb3-regulator" - for PXs3 SoC
|
|
- reg: Specifies offset and length of the register set for the device.
|
|
- clocks: A list of phandles to the clock gate for USB3 glue layer.
|
|
According to the clock-names, appropriate clocks are required.
|
|
- clock-names: Should contain
|
|
"gio", "link" - for Pro4 and Pro5 SoCs
|
|
"link" - for others
|
|
- resets: A list of phandles to the reset control for USB3 glue layer.
|
|
According to the reset-names, appropriate resets are required.
|
|
- reset-names: Should contain
|
|
"gio", "link" - for Pro4 and Pro5 SoCs
|
|
"link" - for others
|
|
|
|
See Documentation/devicetree/bindings/regulator/regulator.txt
|
|
for more details about the regulator properties.
|
|
|
|
Example:
|
|
|
|
usb-glue@65b00000 {
|
|
compatible = "socionext,uniphier-ld20-dwc3-glue",
|
|
"simple-mfd";
|
|
#address-cells = <1>;
|
|
#size-cells = <1>;
|
|
ranges = <0 0x65b00000 0x400>;
|
|
|
|
usb_vbus0: regulators@100 {
|
|
compatible = "socionext,uniphier-ld20-usb3-regulator";
|
|
reg = <0x100 0x10>;
|
|
clock-names = "link";
|
|
clocks = <&sys_clk 14>;
|
|
reset-names = "link";
|
|
resets = <&sys_rst 14>;
|
|
};
|
|
|
|
phy {
|
|
...
|
|
phy-supply = <&usb_vbus0>;
|
|
};
|
|
...
|
|
};
|