linux/arch/mips/alchemy/board-gpr.c

293 lines
6.0 KiB
C

// SPDX-License-Identifier: GPL-2.0-or-later
/*
* GPR board platform device registration (Au1550)
*
* Copyright (C) 2010 Wolfgang Grandegger <wg@denx.de>
*/
#include <linux/delay.h>
#include <linux/init.h>
#include <linux/interrupt.h>
#include <linux/kernel.h>
#include <linux/platform_device.h>
#include <linux/pm.h>
#include <linux/mtd/partitions.h>
#include <linux/mtd/physmap.h>
#include <linux/leds.h>
#include <linux/gpio.h>
#include <linux/i2c.h>
#include <linux/platform_data/i2c-gpio.h>
#include <linux/gpio/machine.h>
#include <asm/bootinfo.h>
#include <asm/idle.h>
#include <asm/reboot.h>
#include <asm/setup.h>
#include <asm/mach-au1x00/au1000.h>
#include <asm/mach-au1x00/gpio-au1000.h>
#include <prom.h>
const char *get_system_type(void)
{
return "GPR";
}
void prom_putchar(char c)
{
alchemy_uart_putchar(AU1000_UART0_PHYS_ADDR, c);
}
static void gpr_reset(char *c)
{
/* switch System-LED to orange (red# and green# on) */
alchemy_gpio_direction_output(4, 0);
alchemy_gpio_direction_output(5, 0);
/* trigger watchdog to reset board in 200ms */
printk(KERN_EMERG "Triggering watchdog soft reset...\n");
raw_local_irq_disable();
alchemy_gpio_direction_output(1, 0);
udelay(1);
alchemy_gpio_set_value(1, 1);
while (1)
cpu_wait();
}
static void gpr_power_off(void)
{
while (1)
cpu_wait();
}
void __init board_setup(void)
{
printk(KERN_INFO "Trapeze ITS GPR board\n");
pm_power_off = gpr_power_off;
_machine_halt = gpr_power_off;
_machine_restart = gpr_reset;
/* Enable UART1/3 */
alchemy_uart_enable(AU1000_UART3_PHYS_ADDR);
alchemy_uart_enable(AU1000_UART1_PHYS_ADDR);
/* Take away Reset of UMTS-card */
alchemy_gpio_direction_output(215, 1);
}
/*
* Watchdog
*/
static struct resource gpr_wdt_resource[] = {
[0] = {
.start = 1,
.end = 1,
.name = "gpr-adm6320-wdt",
.flags = IORESOURCE_IRQ,
}
};
static struct platform_device gpr_wdt_device = {
.name = "adm6320-wdt",
.id = 0,
.num_resources = ARRAY_SIZE(gpr_wdt_resource),
.resource = gpr_wdt_resource,
};
/*
* FLASH
*
* 0x00000000-0x00200000 : "kernel"
* 0x00200000-0x00a00000 : "rootfs"
* 0x01d00000-0x01f00000 : "config"
* 0x01c00000-0x01d00000 : "yamon"
* 0x01d00000-0x01d40000 : "yamon env vars"
* 0x00000000-0x00a00000 : "kernel+rootfs"
*/
static struct mtd_partition gpr_mtd_partitions[] = {
{
.name = "kernel",
.size = 0x00200000,
.offset = 0,
},
{
.name = "rootfs",
.size = 0x00800000,
.offset = MTDPART_OFS_APPEND,
.mask_flags = MTD_WRITEABLE,
},
{
.name = "config",
.size = 0x00200000,
.offset = 0x01d00000,
},
{
.name = "yamon",
.size = 0x00100000,
.offset = 0x01c00000,
},
{
.name = "yamon env vars",
.size = 0x00040000,
.offset = MTDPART_OFS_APPEND,
},
{
.name = "kernel+rootfs",
.size = 0x00a00000,
.offset = 0,
},
};
static struct physmap_flash_data gpr_flash_data = {
.width = 4,
.nr_parts = ARRAY_SIZE(gpr_mtd_partitions),
.parts = gpr_mtd_partitions,
};
static struct resource gpr_mtd_resource = {
.start = 0x1e000000,
.end = 0x1fffffff,
.flags = IORESOURCE_MEM,
};
static struct platform_device gpr_mtd_device = {
.name = "physmap-flash",
.dev = {
.platform_data = &gpr_flash_data,
},
.num_resources = 1,
.resource = &gpr_mtd_resource,
};
/*
* LEDs
*/
static const struct gpio_led gpr_gpio_leds[] = {
{ /* green */
.name = "gpr:green",
.gpio = 4,
.active_low = 1,
},
{ /* red */
.name = "gpr:red",
.gpio = 5,
.active_low = 1,
}
};
static struct gpio_led_platform_data gpr_led_data = {
.num_leds = ARRAY_SIZE(gpr_gpio_leds),
.leds = gpr_gpio_leds,
};
static struct platform_device gpr_led_devices = {
.name = "leds-gpio",
.id = -1,
.dev = {
.platform_data = &gpr_led_data,
}
};
/*
* I2C
*/
static struct gpiod_lookup_table gpr_i2c_gpiod_table = {
.dev_id = "i2c-gpio",
.table = {
/*
* This should be on "GPIO2" which has base at 200 so
* the global numbers 209 and 210 should correspond to
* local offsets 9 and 10.
*/
GPIO_LOOKUP_IDX("alchemy-gpio2", 9, NULL, 0,
GPIO_ACTIVE_HIGH),
GPIO_LOOKUP_IDX("alchemy-gpio2", 10, NULL, 1,
GPIO_ACTIVE_HIGH),
},
};
static struct i2c_gpio_platform_data gpr_i2c_data = {
/*
* The open drain mode is hardwired somewhere or an electrical
* property of the alchemy GPIO controller.
*/
.sda_is_open_drain = 1,
.scl_is_open_drain = 1,
.udelay = 2, /* ~100 kHz */
.timeout = HZ,
};
static struct platform_device gpr_i2c_device = {
.name = "i2c-gpio",
.id = -1,
.dev.platform_data = &gpr_i2c_data,
};
static struct i2c_board_info gpr_i2c_info[] __initdata = {
{
I2C_BOARD_INFO("lm83", 0x18),
}
};
static struct resource alchemy_pci_host_res[] = {
[0] = {
.start = AU1500_PCI_PHYS_ADDR,
.end = AU1500_PCI_PHYS_ADDR + 0xfff,
.flags = IORESOURCE_MEM,
},
};
static int gpr_map_pci_irq(const struct pci_dev *d, u8 slot, u8 pin)
{
if ((slot == 0) && (pin == 1))
return AU1550_PCI_INTA;
else if ((slot == 0) && (pin == 2))
return AU1550_PCI_INTB;
return 0xff;
}
static struct alchemy_pci_platdata gpr_pci_pd = {
.board_map_irq = gpr_map_pci_irq,
.pci_cfg_set = PCI_CONFIG_AEN | PCI_CONFIG_R2H | PCI_CONFIG_R1H |
PCI_CONFIG_CH |
#if defined(__MIPSEB__)
PCI_CONFIG_SIC_HWA_DAT | PCI_CONFIG_SM,
#else
0,
#endif
};
static struct platform_device gpr_pci_host_dev = {
.dev.platform_data = &gpr_pci_pd,
.name = "alchemy-pci",
.id = 0,
.num_resources = ARRAY_SIZE(alchemy_pci_host_res),
.resource = alchemy_pci_host_res,
};
static struct platform_device *gpr_devices[] __initdata = {
&gpr_wdt_device,
&gpr_mtd_device,
&gpr_i2c_device,
&gpr_led_devices,
};
static int __init gpr_pci_init(void)
{
return platform_device_register(&gpr_pci_host_dev);
}
/* must be arch_initcall; MIPS PCI scans busses in a subsys_initcall */
arch_initcall(gpr_pci_init);
static int __init gpr_dev_init(void)
{
gpiod_add_lookup_table(&gpr_i2c_gpiod_table);
i2c_register_board_info(0, gpr_i2c_info, ARRAY_SIZE(gpr_i2c_info));
return platform_add_devices(gpr_devices, ARRAY_SIZE(gpr_devices));
}
device_initcall(gpr_dev_init);