linux/drivers/phy/st/Kconfig

49 lines
1.6 KiB
Plaintext

# SPDX-License-Identifier: GPL-2.0-only
#
# Phy drivers for STMicro platforms
#
config PHY_MIPHY28LP
tristate "STMicroelectronics MIPHY28LP PHY driver for STiH407"
depends on ARCH_STI
select GENERIC_PHY
help
Enable this to support the miphy transceiver (for SATA/PCIE/USB3)
that is part of STMicroelectronics STiH407 SoC.
config PHY_ST_SPEAR1310_MIPHY
tristate "ST SPEAR1310-MIPHY driver"
select GENERIC_PHY
depends on MACH_SPEAR1310 || COMPILE_TEST
help
Support for ST SPEAr1310 MIPHY which can be used for PCIe and SATA.
config PHY_ST_SPEAR1340_MIPHY
tristate "ST SPEAR1340-MIPHY driver"
select GENERIC_PHY
depends on MACH_SPEAR1340 || COMPILE_TEST
help
Support for ST SPEAr1340 MIPHY which can be used for PCIe and SATA.
config PHY_STIH407_USB
tristate "STMicroelectronics USB2 picoPHY driver for STiH407 family"
depends on RESET_CONTROLLER
depends on ARCH_STI || COMPILE_TEST
select GENERIC_PHY
help
Enable this support to enable the picoPHY device used by USB2
and USB3 controllers on STMicroelectronics STiH407 SoC families.
config PHY_STM32_USBPHYC
tristate "STMicroelectronics STM32 USB HS PHY Controller driver"
depends on ARCH_STM32 || COMPILE_TEST
select GENERIC_PHY
help
Enable this to support the High-Speed USB transceivers that are part
of some STMicroelectronics STM32 SoCs.
This driver controls the entire USB PHY block: the USB PHY controller
(USBPHYC) and the two 8-bit wide UTMI+ interfaces. First interface is
used by an HS USB Host controller, and the second one is shared
between an HS USB OTG controller and an HS USB Host controller,
selected by a USB switch.