mirror of https://gitee.com/openkylin/linux.git
48 lines
1.4 KiB
Plaintext
48 lines
1.4 KiB
Plaintext
Allwinner Reduced Serial Bus (RSB) controller
|
|
|
|
The RSB controller found on later Allwinner SoCs is an SMBus like 2 wire
|
|
serial bus with 1 master and up to 15 slaves. It is represented by a node
|
|
for the controller itself, and child nodes representing the slave devices.
|
|
|
|
Required properties :
|
|
|
|
- reg : Offset and length of the register set for the controller.
|
|
- compatible : Shall be "allwinner,sun8i-a23-rsb".
|
|
- interrupts : The interrupt line associated to the RSB controller.
|
|
- clocks : The gate clk associated to the RSB controller.
|
|
- resets : The reset line associated to the RSB controller.
|
|
- #address-cells : shall be 1
|
|
- #size-cells : shall be 0
|
|
|
|
Optional properties :
|
|
|
|
- clock-frequency : Desired RSB bus clock frequency in Hz. Maximum is 20MHz.
|
|
If not set this defaults to 3MHz.
|
|
|
|
Child nodes:
|
|
|
|
An RSB controller node can contain zero or more child nodes representing
|
|
slave devices on the bus. Child 'reg' properties should contain the slave
|
|
device's hardware address. The hardware address is hardwired in the device,
|
|
which can normally be found in the datasheet.
|
|
|
|
Example:
|
|
|
|
rsb@01f03400 {
|
|
compatible = "allwinner,sun8i-a23-rsb";
|
|
reg = <0x01f03400 0x400>;
|
|
interrupts = <0 39 4>;
|
|
clocks = <&apb0_gates 3>;
|
|
clock-frequency = <3000000>;
|
|
resets = <&apb0_rst 3>;
|
|
#address-cells = <1>;
|
|
#size-cells = <0>;
|
|
|
|
pmic@3e3 {
|
|
compatible = "...";
|
|
reg = <0x3e3>;
|
|
|
|
/* ... */
|
|
};
|
|
};
|