linux/Documentation/devicetree/bindings/mtd/m25p80.txt

33 lines
1.3 KiB
Plaintext

* MTD SPI driver for ST M25Pxx (and similar) serial flash chips
Required properties:
- #address-cells, #size-cells : Must be present if the device has sub-nodes
representing partitions.
- compatible : May include a device-specific string consisting of the
manufacturer and name of the chip. Bear in mind the DT binding
is not Linux-only, but in case of Linux, see the "m25p_ids"
table in drivers/mtd/devices/m25p80.c for the list of supported
chips.
Must also include "nor-jedec" for any SPI NOR flash that can be
identified by the JEDEC READ ID opcode (0x9F).
- reg : Chip-Select number
- spi-max-frequency : Maximum frequency of the SPI bus the chip can operate at
Optional properties:
- m25p,fast-read : Use the "fast read" opcode to read data from the chip instead
of the usual "read" opcode. This opcode is not supported by
all chips and support for it can not be detected at runtime.
Refer to your chips' datasheet to check if this is supported
by your chip.
Example:
flash: m25p80@0 {
#address-cells = <1>;
#size-cells = <1>;
compatible = "spansion,m25p80", "nor-jedec";
reg = <0>;
spi-max-frequency = <40000000>;
m25p,fast-read;
};