mirror of https://gitee.com/openkylin/linux.git
bcb48cca23
The Cherryview GPIO controller has 8 or 16 wires connected to the I/O-APIC which can be used directly by the platform/BIOS or drivers. One such wire is used as SCI (System Control Interrupt) which ACPI depends on to be able to trigger GPEs (General Purpose Events). The pinctrl driver itself uses another IRQ resource which is wire OR of all the 8 (or 16) wires and follows what BIOS has programmed to the IntSel register of each pin. Currently the driver masks all interrupts at probe time and this prevents these direct interrupts from working as expected. The reason for this is that some early stage prototypes had some pins misconfigured causing lots of spurious interrupts. We fix this by leaving the interrupt mask untouched. This allows SCI and other direct interrupts work properly. What comes to the possible spurious interrupts we switch the default handler to be handle_bad_irq() instead of handle_simple_irq() (which was not correct anyway). Reported-by: Yu C Chen <yu.c.chen@intel.com> Reported-by: Anisse Astier <anisse@astier.eu> Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com> Signed-off-by: Linus Walleij <linus.walleij@linaro.org> |
||
|---|---|---|
| .. | ||
| Kconfig | ||
| Makefile | ||
| pinctrl-baytrail.c | ||
| pinctrl-broxton.c | ||
| pinctrl-cherryview.c | ||
| pinctrl-intel.c | ||
| pinctrl-intel.h | ||
| pinctrl-merrifield.c | ||
| pinctrl-sunrisepoint.c | ||