arm: check regime, not current state, for ATS write PAR format

In do_ats_write(), rather than using extended_addresses_enabled() to
decide whether the value we get back from get_phys_addr() is a 64-bit
format PAR or a 32-bit one, use arm_s1_regime_using_lpae_format().

This is not really the correct answer, because the PAR format
depends on the AT instruction being used, not just on the
translation regime. However getting this correct requires a
significant refactoring, so that get_phys_addr() returns raw
information about the fault which the caller can then assemble
into a suitable FSR/PAR/syndrome for its purposes, rather than
get_phys_addr() returning a pre-formatted FSR.

However this change at least improves the situation by making
the PAR work correctly for address translation operations done
at AArch64 EL2 on the EL2 translation regime. In particular,
this is necessary for Xen to be able to run in our emulation,
so this seems like a safer interim fix given that we are in freeze.

Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Edgar E. Iglesias <edgar.iglesias@xilinx.com>
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Tested-by: Stefano Stabellini <sstabellini@kernel.org>
Message-id: 1509719814-6191-1-git-send-email-peter.maydell@linaro.org

target/arm/helper.c

@@ -2169,7 +2169,7 @@ static uint64_t do_ats_write(CPUARMState *env, uint64_t value,
 
     ret = get_phys_addr(env, value, access_type, mmu_idx, &phys_addr, &attrs,
                         &prot, &page_size, &fsr, &fi, &cacheattrs);
-    if (extended_addresses_enabled(env)) {
+    if (arm_s1_regime_using_lpae_format(env, mmu_idx)) {
         /* fsr is a DFSR/IFSR value for the long descriptor
          * translation table format, but with WnR always clear.
          * Convert it to a 64-bit PAR.