Also, assert that we don't overflow any of two different offsets into
the TB. Both unwind and goto_tb both record a uint16_t for later use.
This fixes an arm-softmmu test case utilizing NEON in which there is
a TB generated that runs to 7800 opcodes, and compiles to 96k on an
x86_64 host. This overflows the 16-bit offset in which we record the
goto_tb reset offset. Because of that overflow, we install a jump
destination that goes to neverland. Boom.
With this reduced op count, the same TB compiles to about 48k for
aarch64, ppc64le, and x86_64 hosts, and neither assertion fires.
Cc: qemu-stable@nongnu.org
Reported-by: "Jason A. Donenfeld" <Jason@zx2c4.com>
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
I found with qemu 2.11.x or newer that I would get an illegal instruction
error running some Intel binaries on my ARM chromebook. On investigation,
I found it was quitting on memory barriers.
qemu instruction:
mb $0x31
was translating as:
0x604050cc: 5bf07ff5 blpl #0x600250a8
After patch it gives:
0x604050cc: f57ff05b dmb ish
In short, I found INSN_DMB_ISH (memory barrier for ARMv7) appeared to be
correct based on online docs, but due to some endian-related shenanigans it
had to be byte-swapped to suit qemu; it appears INSN_DMB_MCR (memory
barrier for ARMv6) also should be byte swapped (and this patch does so).
I have not checked for correctness of aarch64's barrier instruction.
Cc: qemu-stable@nongnu.org
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Henry Wertz <hwertz10@gmail.com>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
The code sequence we were generating was only good for unsigned
comparisons. For signed comparisions, use the sequence from gcc.
Fixes booting of ppc64 firmware, with a patch changing the code
sequence for ppc comparisons.
Tested-by: Michael Roth <mdroth@linux.vnet.ibm.com>
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
It's not even clear what the interface REG and VAL32 were supposed to mean.
All uses had REG = 0 and VAL32 was the bitset assigned to the destination.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Move constants before all of the functions.
Move tcg_out_<format> functions before all
of the others. No functional change.
Signed-off-by: Richard Henderson <rth@twiddle.net>
We are not going to use ldrd for loading the comparator
for 32-bit guests, so don't limit cmp_off to 8 bits then.
This eliminates one insn in the tlb load for some guests.
Signed-off-by: Richard Henderson <rth@twiddle.net>
Use UBFX to avoid limitation on CPU_TLB_BITS. Since we're dropping
the initial shift, we need to replace the page masking. We can use
MOVW+BIC to do this without shifting. The result is the same size
as the armv6 path with one less conditional instruction.
Signed-off-by: Richard Henderson <rth@twiddle.net>
Dispense with TCGBackendData, as it has never been used for more than
holding a single pointer. Use a define in the cpu/tcg-target.h to
signal requirement for TCGLabelQemuLdst, so that we can drop the no-op
tcg-be-null.h stubs. Rename tcg-be-ldst.h to tcg-ldst.inc.c.
Reviewed-by: Paolo Bonzini <pbonzini@redhat.com>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Patch 85aa80813d changed the IF emitting the TST instruction,
but failed to change the ?: converting CMP to CMPEQ, so the
result of the TST is ignored.
Signed-off-by: Richard Henderson <rth@twiddle.net>
The new placement of the TB means that we can use one insn
to load the goto_tb destination directly from the TB.
Signed-off-by: Richard Henderson <rth@twiddle.net>
In theory this would re-enable usage of QEMU on an armv4 host.
Whether this is worthwhile is debatable -- we've been unconditionally
issuing the armv5t BX instruction in the prologue since 2011 without
complaint. Possibly we should simply require an armv6 host.
Signed-off-by: Richard Henderson <rth@twiddle.net>
This will let us choose how to interpret a given constraint
depending on whether the opcode is 32- or 64-bit. Which will
let us share more constraint combinations between opcodes.
At the same time, change the interface to return the advanced
pointer instead of passing it in/out by reference.
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Signed-off-by: Richard Henderson <rth@twiddle.net>
This will allow the target to tailor the constraints to the
auto-detected ISA extensions.
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Signed-off-by: Richard Henderson <rth@twiddle.net>
This allows us to use this detection within the TCG_TARGET_HAS_*
macros, instead of requiring a function call into tcg-target.inc.c.
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Previously we allowed fully unaligned operations, but not operations
that are aligned but with less alignment than the operation size.
In addition, arm32, ia64, mips, and sparc had been omitted from the
previous overalignment patch, which would have led to that alignment
being enforced.
Signed-off-by: Richard Henderson <rth@twiddle.net>
While we can store constants via constrants on INDEX_op_st_i32 et al,
we weren't able to spill constants to backing store.
Add a new backend interface, tcg_out_sti, which may store the constant
(and is allowed to fail). Rearrange the temp_* helpers so that we only
attempt to directly store a constant when the temp is becoming dead/free.
Signed-off-by: Richard Henderson <rth@twiddle.net>
Briefly describe in a comment how direct block chaining is done. It
should help in understanding of the following data fields.
Rename some fields in TranslationBlock and TCGContext structures to
better reflect their purpose (dropping excessive 'tb_' prefix in
TranslationBlock but keeping it in TCGContext):
tb_next_offset => jmp_reset_offset
tb_jmp_offset => jmp_insn_offset
tb_next => jmp_target_addr
jmp_next => jmp_list_next
jmp_first => jmp_list_first
Avoid using a magic constant as an invalid offset which is used to
indicate that there's no n-th jump generated.
Signed-off-by: Sergey Fedorov <serge.fdrv@gmail.com>
Signed-off-by: Sergey Fedorov <sergey.fedorov@linaro.org>
Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Ensure direct jump patching in ARM is atomic by using
atomic_read()/atomic_set() for code patching.
Signed-off-by: Sergey Fedorov <serge.fdrv@gmail.com>
Signed-off-by: Sergey Fedorov <sergey.fedorov@linaro.org>
Message-Id: <1461341333-19646-8-git-send-email-sergey.fedorov@linaro.org>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Check for CONFIG_DEBUG_TCG instead of NDEBUG, drop now useless code.
Cc: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Message-id: 1461228530-14852-2-git-send-email-aurelien@aurel32.net
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
The TCG code is quite performance sensitive, but at the same time can
also be quite tricky. That is why asserts that can be enabled with the
--enable-debug-tcg configure option.
This used to work the following way:
| #include "config.h"
|
| ...
|
| #if !defined(CONFIG_DEBUG_TCG) && !defined(NDEBUG)
| /* define it to suppress various consistency checks (faster) */
| #define NDEBUG
| #endif
|
| ...
|
| #include <assert.h>
Since commit 757e725b (tcg: Clean up includes) "config.h" as been
replaced by "qemu/osdep.h" which itself includes <assert.h>. As a
consequence the assertions are always enabled, even when using
--disable-debug-tcg, causing a performance regression, especially on
targets with many registers. For instance on qemu-system-ppc the
speed difference is about 15%.
tcg_debug_assert is controlled directly by CONFIG_DEBUG_TCG and already
uses in some places. This patch replaces all the calls to assert into
calss to tcg_debug_assert.
Cc: Peter Maydell <peter.maydell@linaro.org>
Cc: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Message-id: 1461228530-14852-1-git-send-email-aurelien@aurel32.net
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Commit 757e725b58 added a number of #include "qemu/osdep.h"
files to the tcg-target.c files (as they were named at the time).
These are unnecessary because these files are not standalone C
files, and the tcg/tcg.c file which includes them will have
already included osdep.h on their behalf. Remove the unneeded
include directives.
Reviewed-by: Eric Blake <eblake@redhat.com>
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Message-Id: <1456238983-10160-4-git-send-email-peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Rename the per-architecture tcg-target.c files to tcg-target.inc.c.
This makes it clearer that they are not intended to be standalone
C files, but are instead #included into another source file.
Reviewed-by: Eric Blake <eblake@redhat.com>
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Message-Id: <1456238983-10160-2-git-send-email-peter.maydell@linaro.org>
Signed-off-by: Richard Henderson <rth@twiddle.net>
Richard Henderson