spi: sh-msiof: Add reset of registers before starting transfer
In accordance with hardware specification Ver 1.0, reset register transmission / reception setting before transfer. Signed-off-by: Hiromitsu Yamasaki <hiromitsu.yamasaki.ym@renesas.com> [geert: Use readl_poll_timeout_atomic()] Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be> Reviewed-by: Wolfram Sang <wsa+renesas@sang-engineering.com> Signed-off-by: Mark Brown <broonie@kernel.org>
This commit is contained in:
parent
9115b4d89b
commit
fedd694068
|
@ -132,6 +132,8 @@ struct sh_msiof_spi_priv {
|
|||
#define CTR_TFSE BIT(14) /* Transmit Frame Sync Signal Output Enable */
|
||||
#define CTR_TXE BIT(9) /* Transmit Enable */
|
||||
#define CTR_RXE BIT(8) /* Receive Enable */
|
||||
#define CTR_TXRST BIT(1) /* Transmit Reset */
|
||||
#define CTR_RXRST BIT(0) /* Receive Reset */
|
||||
|
||||
/* FCTR */
|
||||
#define FCTR_TFWM_MASK GENMASK(31, 29) /* Transmit FIFO Watermark */
|
||||
|
@ -241,6 +243,19 @@ static irqreturn_t sh_msiof_spi_irq(int irq, void *data)
|
|||
return IRQ_HANDLED;
|
||||
}
|
||||
|
||||
static void sh_msiof_spi_reset_regs(struct sh_msiof_spi_priv *p)
|
||||
{
|
||||
u32 mask = CTR_TXRST | CTR_RXRST;
|
||||
u32 data;
|
||||
|
||||
data = sh_msiof_read(p, CTR);
|
||||
data |= mask;
|
||||
sh_msiof_write(p, CTR, data);
|
||||
|
||||
readl_poll_timeout_atomic(p->mapbase + CTR, data, !(data & mask), 1,
|
||||
100);
|
||||
}
|
||||
|
||||
static const u32 sh_msiof_spi_div_array[] = {
|
||||
SCR_BRDV_DIV_1, SCR_BRDV_DIV_2, SCR_BRDV_DIV_4,
|
||||
SCR_BRDV_DIV_8, SCR_BRDV_DIV_16, SCR_BRDV_DIV_32,
|
||||
|
@ -920,6 +935,9 @@ static int sh_msiof_transfer_one(struct spi_controller *ctlr,
|
|||
bool swab;
|
||||
int ret;
|
||||
|
||||
/* reset registers */
|
||||
sh_msiof_spi_reset_regs(p);
|
||||
|
||||
/* setup clocks (clock already enabled in chipselect()) */
|
||||
if (!spi_controller_is_slave(p->ctlr))
|
||||
sh_msiof_spi_set_clk_regs(p, clk_get_rate(p->clk), t->speed_hz);
|
||||
|
|
Loading…
Reference in New Issue