This patch checks inline_data one more time under the inode page lock whether
its inline_data is converted or not.
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
I think we need to let the dirty node pages remain in the page cache instead
of rewriting them in their places.
So, after done with successful recovery, write_checkpoint will flush all of them
through the normal write path.
Through this, we can avoid potential error cases in terms of block allocation.
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
The init_inode_metadata calls truncate_blocks when error is occurred.
The callers holds f2fs_lock_op, so we should not call it again in
truncate_blocks.
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
Any checkpoint should not be done during the core roll-forward procedure.
Especially, it includes error cases too.
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
There are two rules when EIO is occurred.
1. don't write any checkpoint data to preserve the previous checkpoint
2. don't lose the cached dentry/node/meta pages
So, at first, this patch adds set_page_dirty in f2fs_write_end_io's failure.
Then, writing checkpoint/dentry/node blocks is not allowed.
Note that, for the data pages, we can't just throw away by redirtying them.
Otherwise, kworker can fall into infinite loop to flush them.
(Ref. xfstests/019)
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
It needs to check s_dirty under cp_mutex, since s_dirty is reset under that
mutex.
And previous condition was not correct, since we can omit doing checkpoint
when checkpoint was done followed by all the node pages were written back.
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
This patch gives another chance to try mount process when we encounter an error.
This makes an effect on the roll-forward recovery failures as well.
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
The generic_shutdown_super calls sync_filesystem, evict_inode, and then
f2fs_put_super. In f2fs_evict_inode, we remain some dirty inode information
so we should release them at f2fs_put_super.
Reviewed-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
This is the errorneous scenario.
1. write data
2. do checkpoint
3. produce some dirty node pages by the gc thread
4. write back dirty node pages
5. f2fs_put_super will skip the checkpoint, since dirty count for node pages is
zero.
This patch removes such the wrong condition check.
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
This patch fixes not to skip xattr recovery and inline xattr/data recovery
order.
Reviewed-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
During the recovery, we should clear the inline_xattr flag if its xattr node
block is recovered.
Reviewed-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
If an inode are fsynced multiple times with fsync & dent marks, this inode will
set FI_INC_LINK at find_fsync_dnodes during the recovery.
But, in recover_inode, recover_dentry doesn't clear that flag when multiple hits
were occurred.
So this patch removes the flag for the further consistency.
Reviewed-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
If a new inode page is needed for recover_dentry, we should assing i_inline
as zero.
Reviewed-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
This patch adds a parentheses to make clear for condition check.
And also it changes the return type for better meanings.
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
If mkwrite is called to an inode having inline_data, it can overwrite the data
index space as NEW_ADDR. (e.g., the first 4 bytes are coincidently zero)
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
Fix typo and some grammatical errors.
The words "filesystem" and "readahead" are being used without the space treewide.
Signed-off-by: Park Ju Hyung <qkrwngud825@gmail.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
This patch uses for_each_set_bit to simplify some codes in f2fs.
Signed-off-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
This patch adds f2fs_balance_fs in expand_inode_data to avoid allocation failure
with segment.
Signed-off-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
When inode is evicted, all the page cache belong to this inode should be
released including the xattr node page. But previously we didn't do this, this
patch fixed this issue.
v2:
o reposition invalidate_mapping_pages() to the right place suggested by
Jaegeuk Kim.
Signed-off-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
When we recover data of inode in roll-forward procedure, and the inode has both
inline data and inline xattr. We may skip recovering inline xattr if we recover
inline data form node page first.
This patch will fix the problem that we lost inline xattr data in above
scenario.
Signed-off-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
We do not need to block on ->node_write among different node page writers e.g.
fsync/flush, unless we have a node page writer from write_checkpoint.
So it's better use rw_semaphore instead of mutex type for ->node_write to
promote performance.
Signed-off-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
There are redundant lines in allocate_data_block.
In this function, we call refresh_sit_entry with old seg and old curseg.
After that, we call locate_dirty_segment with old curseg.
But, the new address is always allocated from old curseg and
we call locate_dirty_segment with old curseg in refresh_sit_entry.
So, we do not need to call locate_dirty_segment with old curseg again.
We've discussed like below:
Jaegeuk said:
"When considering SSR, we need to take care of the following scenario.
- old segno : X
- new address : Z
- old curseg : Y
This means, a new block is supposed to be written to Z from X.
And Z is newly allocated in the same path from Y.
In that case, we should trigger locate_dirty_segment for Y, since
it was a current_segment and can be dirty owing to SSR.
But that was not included in the dirty list."
Changman said:
"We already choosed old curseg(Y) and then we allocate new address(Z) from old
curseg(Y). After that we call refresh_sit_entry(old address, new address).
In the funcation, we call locate_dirty_segment with old seg and old curseg.
So calling locate_dirty_segment after refresh_sit_entry again is redundant."
Jaegeuk said:
"Right. The new address is always allocated from old_curseg."
Reviewed-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Dongho Sim <dh.sim@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
If the bit is already set, we don't need to reset it, and vice versa.
Because we don't need to make the caches dirty for that.
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
This patch enforces in-place-updates only when fdatasync is requested.
If we adopt this in-place-updates for the fdatasync, we can skip to write the
recovery information.
Reviewed-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
This patch intends to improve the fsync performance by skipping remaining the
recovery information, only when there is no data that we should recover.
Reviewed-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
This patch introduces a inode number list in which represents inodes having
appended data writes or updated data writes after last checkpoint.
This will be used at fsync to determine whether the recovery information
should be written or not.
Reviewed-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
For better ino management, this patch replaces the data structure from list
to radix tree.
Reviewed-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
This patch changes the naming of orphan-related data structures to use as
inode numbers managed globally.
Later, we can use this facility for managing any inode number lists.
Reviewed-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
This patch punches out the core functions to manage the inode numbers.
Reviewed-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
This patch adds a mount option, nobarrier, in f2fs.
The assumption in here is that file system keeps the IO ordering, but
doesn't care about cache flushes inside the storages.
Reviewed-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
We should put root inode correctly in error path of fill_super, otherwise we
may encounter a leak case of inode resource.
Signed-off-by: Chao Yu <chao2.yu@samsung.com>
Reviewed-by: Gu Zheng <guz.fnst@cn.fujitsu.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
Now new interface ->rename2() is added to VFS, here are related description:
https://lkml.org/lkml/2014/2/7/873https://lkml.org/lkml/2014/2/7/758
This patch adds function f2fs_rename2() to support ->rename2() including
handling both RENAME_EXCHANGE and RENAME_NOREPLACE flag.
Signed-off-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
Otherwise, if a large amount of direct IO writes were done, the
segment allocation may be failed because no enough segments are gced.
Changes:
v2: add f2fs_balance_fs into __get_data_block instead of f2fs_direct_IO.
Signed-off-by: Huang, Ying <ying.huang@intel.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
In __set_test_and_free we will check whether all segment are free in one section
When free one segment, in order to set section to free status.
But the searching region of segmap is from start segno to last segno of f2fs,
it's not necessary. So let's just only check all segment bitmap of target
section.
Signed-off-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
We assume that modification of some special application could result in zeroed
name_len, or it is consciously made by somebody. We will deadloop in
find_in_block when name_len of dir entry is zero.
This patch is added for preventing deadloop in above scenario.
change log from v1:
o use f2fs_bug_on rather than break out from searching dir entry suggested by
Jaegeuk Kim.
Jaegeuk describe:
"Well, IMO, it would be good to add f2fs_bug_on() here with a specific comment.
In the current phase of f2fs, it is more important to investigate the file
system bugs, rather than workarounds for any corrupted images.
And, definitely it needs to stop the kernel if any corrupted image was mounted,
so that we can figure out where the bugs are occurred."
Suggested-by: Jaegeuk Kim <jaegeuk@kernel.org>
Signed-off-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
In this patch we use below inner macro and function to clean up codes.
1. ADDRS_PER_PAGE
2. SM_I
3. f2fs_readonly
Signed-off-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
When we fail in ->write_begin()/->direct_IO(), our allocated node block in disk
and page cache are still kept, despite these may not be used again.
This patch introduce f2fs_write_failed() to handle the error case of these two
interfaces, it will truncate page cache and blocks of this file according to
i_size.
Signed-off-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
Jaegeuk Kim