Commit Graph

3 Commits

Author SHA1 Message Date
Linus Walleij 1c5fb66afa pinctrl: Include <linux/gpio/driver.h> nothing else
These drivers are GPIO drivers, and the do not need to use the
legacy header in <linux/gpio.h>, go directly for
<linux/gpio/driver.h> instead.

Replace any use of GPIOF_* with 0/1, these flags are for
consumers, not drivers.

Get rid of a few gpio_to_irq() users that was littering
around the place, use local callbacks or avoid using it at
all.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
2018-09-14 15:10:57 +02:00
Paul Gortmaker 23d511f6fe pinctrl: vt8500: make bool drivers explicitly non-modular
None of the Kconfigs for any of these drivers are tristate, meaning
that they currently are not being built as a module by anyone.

Lets remove the modular code that is essentially orphaned, so that
when reading the drivers there is no doubt they are builtin-only.  All
drivers get the exact same change, so they are handled in batch.

Changes are (1) use builtin_platform_driver, (2) use init.h header
(3) delete module_exit related code, (4) delete MODULE_DEVICE_TABLE,
(5) delete MODULE_LICENCE/MODULE_AUTHOR and associated tags and (6)
drop ".remove" code and prevent sysfs unbind attempts to call ".remove".

Once this is done, the shared remove function in wmt.[ch] is no longer
used and hence it is removed as well.

Since module_platform_driver() uses the same init level priority as
builtin_platform_driver() the init ordering remains unchanged with
this commit.

Also note that MODULE_DEVICE_TABLE is a no-op for non-modular code.

We also delete the MODULE_LICENSE etc. tags since all that information
is already contained at the top of each file in the comments.

Cc: Tony Prisk <linux@prisktech.co.nz>
Cc: Linus Walleij <linus.walleij@linaro.org>
Cc: linux-gpio@vger.kernel.org
Signed-off-by: Paul Gortmaker <paul.gortmaker@windriver.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
2016-11-15 10:04:20 +01:00
Tony Prisk 170c6152ae pinctrl: gpio: vt8500: Add pincontrol driver for arch-vt8500
This patch adds support for the GPIO/pinmux controller found on the VIA
VT8500 and Wondermedia WM8xxx-series SoCs.

Each pin within the controller is capable of operating as a GPIO or as
an alternate function. The pins are numbered according to their control
bank/bit so that if new pins are added, the existing numbering is maintained.

All currently supported SoCs are included: VT8500, WM8505, WM8650, WM8750 and
WM8850.

Signed-off-by: Tony Prisk <linux@prisktech.co.nz>
Reviewed-by: Stephen Warren <swarren@nvidia.com>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
2013-04-04 18:00:02 +13:00