43 lines
1.3 KiB
Plaintext
43 lines
1.3 KiB
Plaintext
* CSR SiRFprimaII Serial Peripheral Interface
|
|
|
|
Required properties:
|
|
- compatible : Should be "sirf,prima2-spi", "sirf,prima2-usp"
|
|
or "sirf,atlas7-usp"
|
|
- reg : Offset and length of the register set for the device
|
|
- interrupts : Should contain SPI interrupt
|
|
- resets: phandle to the reset controller asserting this device in
|
|
reset
|
|
See ../reset/reset.txt for details.
|
|
- dmas : Must contain an entry for each entry in clock-names.
|
|
See ../dma/dma.txt for details.
|
|
- dma-names : Must include the following entries:
|
|
- rx
|
|
- tx
|
|
- clocks : Must contain an entry for each entry in clock-names.
|
|
See ../clocks/clock-bindings.txt for details.
|
|
|
|
- #address-cells: Number of cells required to define a chip select
|
|
address on the SPI bus. Should be set to 1.
|
|
- #size-cells: Should be zero.
|
|
|
|
Optional properties:
|
|
- spi-max-frequency: Specifies maximum SPI clock frequency,
|
|
Units - Hz. Definition as per
|
|
Documentation/devicetree/bindings/spi/spi-bus.txt
|
|
- cs-gpios: should specify GPIOs used for chipselects.
|
|
|
|
Example:
|
|
|
|
spi0: spi@b00d0000 {
|
|
compatible = "sirf,prima2-spi";
|
|
reg = <0xb00d0000 0x10000>;
|
|
interrupts = <15>;
|
|
dmas = <&dmac1 9>,
|
|
<&dmac1 4>;
|
|
dma-names = "rx", "tx";
|
|
#address-cells = <1>;
|
|
#size-cells = <0>;
|
|
clocks = <&clks 19>;
|
|
resets = <&rstc 26>;
|
|
};
|