ARM: dts: qcom: msm8974-hammerhead: increase load on l20 for sdhci

The kernel would not boot on the hammerhead hardware due to the
following error:

mmc0: Timeout waiting for hardware interrupt.
mmc0: sdhci: ============ SDHCI REGISTER DUMP ===========
mmc0: sdhci: Sys addr:  0x00000200 | Version:  0x00003802
mmc0: sdhci: Blk size:  0x00000200 | Blk cnt:  0x00000200
mmc0: sdhci: Argument:  0x00000000 | Trn mode: 0x00000023
mmc0: sdhci: Present:   0x03e80000 | Host ctl: 0x00000034
mmc0: sdhci: Power:     0x00000001 | Blk gap:  0x00000000
mmc0: sdhci: Wake-up:   0x00000000 | Clock:    0x00000007
mmc0: sdhci: Timeout:   0x0000000e | Int stat: 0x00000000
mmc0: sdhci: Int enab:  0x02ff900b | Sig enab: 0x02ff100b
mmc0: sdhci: AC12 err:  0x00000000 | Slot int: 0x00000000
mmc0: sdhci: Caps:      0x642dc8b2 | Caps_1:   0x00008007
mmc0: sdhci: Cmd:       0x00000c1b | Max curr: 0x00000000
mmc0: sdhci: Resp[0]:   0x00000c00 | Resp[1]:  0x00000000
mmc0: sdhci: Resp[2]:   0x00000000 | Resp[3]:  0x00000000
mmc0: sdhci: Host ctl2: 0x00000008
mmc0: sdhci: ADMA Err:  0x00000000 | ADMA Ptr: 0x70040220
mmc0: sdhci: ============================================
mmc0: Card stuck in wrong state! mmcblk0 card_busy_detect status: 0xe00
mmc0: cache flush error -110
mmc0: Reset 0x1 never completed.

This patch increases the load on l20 to 0.2 amps for the sdhci
and allows the device to boot normally.

Signed-off-by: Bhushan Shah <bshah@kde.org>
Signed-off-by: Brian Masney <masneyb@onstation.org>
Suggested-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Tested-by: Brian Masney <masneyb@onstation.org>
Signed-off-by: Andy Gross <andy.gross@linaro.org>

arch/arm/boot/dts/qcom-msm8974-lge-nexus5-hammerhead.dts

@@ -189,6 +189,8 @@ l20 {
 						regulator-max-microvolt = <2950000>;
 
 						regulator-boot-on;
+						regulator-system-load = <200000>;
+						regulator-allow-set-load;
 					};
 
 					l21 {