We get MMIOs with the weirdest instructions. But every time we do,
we need to improve our emulator to implement them.
So let's do that - this time it's lbzux and lhax's round.
Signed-off-by: Alexander Graf <agraf@suse.de>
Signed-off-by: Avi Kivity <avi@redhat.com>
We have a 32 bit value in the PACA to store XER in. We also do an stw
when storing XER in there. But then we load it with ld, completely
screwing it up on every entry.
Welcome to the Big Endian world.
Signed-off-by: Alexander Graf <agraf@suse.de>
Signed-off-by: Avi Kivity <avi@redhat.com>
BATs can't only be written to, you can also read them out!
So let's implement emulation for reading BAT values again.
While at it, I also made BAT setting flush the segment cache,
so we're absolutely sure there's no MMU state left when writing
BATs.
Signed-off-by: Alexander Graf <agraf@suse.de>
Signed-off-by: Avi Kivity <avi@redhat.com>
We emulate the mfsrin instruction already, that passes the SR number
in a register value. But we lacked support for mfsr that encoded the
SR number in the opcode.
So let's implement it.
Signed-off-by: Alexander Graf <agraf@suse.de>
Signed-off-by: Avi Kivity <avi@redhat.com>
When trying to read or store vcpu register data, we should also make
sure the vcpu is actually loaded, so we're 100% sure we get the correct
values.
Signed-off-by: Alexander Graf <agraf@suse.de>
Signed-off-by: Avi Kivity <avi@redhat.com>
When the guest activates the FPU, we load it up. That's fine when
it wasn't activated before on the host, but if it was we end up
reloading FPU values from last time the FPU was deactivated on the
host without writing the proper values back to the vcpu struct.
This patch checks if the FPU is enabled already and if so just doesn't
bother activating it, making FPU operations survive guest context switches.
Signed-off-by: Alexander Graf <agraf@suse.de>
Signed-off-by: Avi Kivity <avi@redhat.com>
The current check_ext function reads the instruction and then does
the checking. Let's split the reading out so we can reuse it for
different functions.
Signed-off-by: Alexander Graf <agraf@suse.de>
Signed-off-by: Avi Kivity <avi@redhat.com>
This patch makes the VSID of mapped pages always reflecting all special cases
we have, like split mode.
It also changes the tlbie mask to 0x0ffff000 according to the spec. The mask
we used before was incorrect.
Signed-off-by: Alexander Graf <agraf@suse.de>
Signed-off-by: Avi Kivity <avi@redhat.com>
DSISR is only defined as 32 bits wide. So let's reflect that in the
structs too.
Signed-off-by: Alexander Graf <agraf@suse.de>
Signed-off-by: Avi Kivity <avi@redhat.com>
Userspace can tell us that it wants to trigger an interrupt. But
so far it can't tell us that it wants to stop triggering one.
So let's interpret the parameter to the ioctl that we have anyways
to tell us if we want to raise or lower the interrupt line.
Signed-off-by: Alexander Graf <agraf@suse.de>
v2 -> v3:
- Add CAP for unset irq
Signed-off-by: Avi Kivity <avi@redhat.com>
On PowerPC we can go into MMU Split Mode. That means that either
data relocation is on but instruction relocation is off or vice
versa.
That mode didn't work properly, as we weren't always flushing
entries when going into a new split mode, potentially mapping
different code or data that we're supposed to.
Signed-off-by: Alexander Graf <agraf@suse.de>
Signed-off-by: Avi Kivity <avi@redhat.com>
Direct maps are linear translations for a section of memory, used for
real mode or with large pages. As such, they are independent of the guest
levels.
Teach the mmu about this by making page->role.glevels = 0 for direct maps.
This allows direct maps to be shared among real mode and the various paging
modes.
Signed-off-by: Avi Kivity <avi@redhat.com>
- Check reserved bits only if CR4.PAE=1 or CR4.PSE=1 when guest #PF occurs
- Fix a typo in reset_rsvds_bits_mask()
Signed-off-by: Xiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Reviewed-by: Marcelo Tosatti <mtosatti@redhat.com>
Signed-off-by: Avi Kivity <avi@redhat.com>
Document that KVM_REQ_PENDING_TIMER is implicitly used during guest
entry.
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Signed-off-by: Avi Kivity <avi@redhat.com>
When CMPXCHG8B is executed without LOCK prefix it is racy. Preserve this
behaviour in emulator too.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Avi Kivity <avi@redhat.com>
Decode CMPXCHG8B destination operand in decoding stage. Fixes regression
introduced by "If LOCK prefix is used dest arg should be memory" commit.
This commit relies on dst operand be decoded at the beginning of an
instruction emulation.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Avi Kivity <avi@redhat.com>
Make sure that rflags is committed only after successful instruction
emulation.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Avi Kivity <avi@redhat.com>
Unify all conditions that get us back into emulator after returning from
userspace.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
To optimize "rep ins" instruction do IO in big chunks ahead of time
instead of doing it only when required during instruction emulation.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Currently when string instruction is only partially complete we go back
to a guest mode, guest tries to reexecute instruction and exits again
and at this point emulation continues. Avoid all of this by restarting
instruction without going back to a guest mode, but return to a guest
mode each 1024 iterations to allow interrupt injection. Pending
exception causes immediate guest entry too.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
c->eip is never written back in case of emulation failure, so no need to
set it to old value.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Currently emulation is done outside of emulator so things like doing
ins/outs to/from mmio are broken it also makes it hard (if not impossible)
to implement single stepping in the future. The implementation in this
patch is not efficient since it exits to userspace for each IO while
previous implementation did 'ins' in batches. Further patch that
implements pio in string read ahead address this problem.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
in/out emulation is broken now. The breakage is different depending
on where IO device resides. If it is in userspace emulator reports
emulation failure since it incorrectly interprets kvm_emulate_pio()
return value. If IO device is in the kernel emulation of 'in' will do
nothing since kvm_emulate_pio() stores result directly into vcpu
registers, so emulator will overwrite result of emulation during
commit of shadowed register.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Add decoding of X,Y parameters from Intel SDM which are used by string
instruction to specify source and destination. Use this new decoding
to implement movs, cmps, stos, lods in a generic way.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
All struct operand fields are initialized during decoding for all
operand types except OP_MEM, but there is no reason for that. Move
OP_MEM operand initialization into decoding stage for consistency.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
When x86_emulate_insn() does not know how to emulate instruction it
exits via cannot_emulate label in all cases except when emulating
grp3. Fix that.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
If LOCK prefix is used dest arg should be memory, otherwise instruction
should generate #UD.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Return X86EMUL_PROPAGATE_FAULT is fault was injected. Also inject #UD
for those instruction when appropriate.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Resent spec says that for 0f (20|21|22|23) the 2 bits in the mod field
are ignored. Interestingly enough older spec says that 11 is only valid
encoding.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Eliminate the need to call back into KVM to get it from emulator.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Use this callback instead of directly call kvm function. Also rename
realmode_(set|get)_cr to emulator_(set|get)_cr since function has nothing
to do with real mode.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
kvm_coalesced_mmio_init() keeps to hold the addresses of a coalesced
mmio ring page and dev even after it has freed them.
Also, if this function fails, though it might be rare, it seems to be
suggesting the system's serious state: so we'd better stop the works
following the kvm_creat_vm().
This patch clears these problems.
We move the coalesced mmio's initialization out of kvm_create_vm().
This seems to be natural because it includes a registration which
can be done only when vm is successfully created.
Signed-off-by: Takuya Yoshikawa <yoshikawa.takuya@oss.ntt.co.jp>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Make use of bool as return values, and remove some useless
bool value converting. Thanks Avi to point this out.
Signed-off-by: Gui Jianfeng <guijianfeng@cn.fujitsu.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Mov reg, cr instruction doesn't change flags in any meaningful way, so
no need to update rflags after instruction execution.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Check return value against correct define instead of open code
the value.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Alexander Graf