linux/drivers/net/wireless/ath/ath9k
Felix Fietkau 59505c02e1 ath9k: limit multicast buffer hardware queue depth
The CAB (Content after Beacon) queue is used for beacon-triggered
transmission of buffered multicast frames. If lots of multicast frames
were buffered and this queue fills up, it drowns out all regular
traffic. To limit the damage that buffered traffic can do, try to limit
the queued data to becaon_interval / 8.

Signed-off-by: Felix Fietkau <nbd@openwrt.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
2013-06-12 15:06:49 -04:00
..
Kconfig Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless 2013-06-12 14:35:23 -04:00
Makefile ath9k: Use minstrel rate control by default 2013-06-12 10:20:58 -04:00
ahb.c ath9k: use the devres API for allocations/mappings 2013-01-07 15:16:51 -05:00
ani.c ath9k: Remove redundant code 2013-06-12 14:59:11 -04:00
ani.h ath9k: Remove unused ANI macros 2013-06-12 14:59:11 -04:00
antenna.c ath9k: Add a module parameter to enable diversity 2012-09-24 14:59:11 -04:00
ar955x_1p0_initvals.h ath9k_hw: Update initvals for QCA955x 2013-01-09 14:37:11 -05:00
ar5008_initvals.h ath9k: fix column header comments for some initval arrays 2013-01-07 15:16:53 -05:00
ar5008_phy.c ath9k: Do not maintain ANI state per-channel 2013-06-03 15:55:48 -04:00
ar9001_initvals.h ath9k: fix column header comments for some initval arrays 2013-01-07 15:16:53 -05:00
ar9002_calib.c Show actual timeout value in failed calibration messages. 2013-03-27 13:39:08 -04:00
ar9002_hw.c ath9k: Enable WoW only for AR9462 2013-06-03 15:55:46 -04:00
ar9002_initvals.h ath9k: Enable WoW only for AR9462 2013-06-03 15:55:46 -04:00
ar9002_mac.c
ar9002_phy.c ath9k_hw: ar9002_hw_spectral_scan_config() can be static 2013-01-14 15:10:40 -05:00
ar9002_phy.h
ar9003_2p2_initvals.h Revert "ath9k_hw: Update rx gain initval to improve rx sensitivity" 2013-06-12 10:20:58 -04:00
ar9003_calib.c ath9k_hw: Enable manual peak calibration for AR9485 2013-05-17 14:31:08 -04:00
ar9003_eeprom.c ath9k_hw: Fix fixed antenna for AR9462 2013-03-06 16:28:57 -05:00
ar9003_eeprom.h ath9k: use correct OTP register offsets for AR9550 2013-05-28 13:43:10 -04:00
ar9003_hw.c Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless 2013-01-28 13:54:03 -05:00
ar9003_mac.c ath9k: remove useless flag conversation. 2013-05-30 14:42:34 -04:00
ar9003_mac.h
ar9003_mci.c ath9k: Fix MCI reset in BT cal_req 2012-11-21 14:16:01 -05:00
ar9003_mci.h ath9k: Add new BT profile info A2DP_Voice 2012-10-29 15:19:30 -04:00
ar9003_paprd.c ath9k_hw: fix PA predistortion miscalibration 2013-05-29 15:22:42 -04:00
ar9003_phy.c ath9k: Fix ofdm weak signal configuration 2013-06-12 14:59:11 -04:00
ar9003_phy.h ath9k_hw: Add TempCompensation feature for AR9550 2013-01-09 14:37:11 -05:00
ar9003_rtt.c ath9k_hw: Fix RTT calibration 2012-05-15 17:27:55 -04:00
ar9003_rtt.h ath9k_hw: Fix RTT calibration 2012-05-15 17:27:55 -04:00
ar9330_1p1_initvals.h ath9k: de-duplicate initvals 2012-06-28 14:37:47 -04:00
ar9330_1p2_initvals.h ath9k: de-duplicate initvals 2012-06-28 14:37:47 -04:00
ar9340_initvals.h ath9k_hw: add tx gain tables for newer devices 2013-01-11 14:50:00 -05:00
ar9462_2p0_initvals.h ath9k_hw: Update initvals for AR9462 2013-03-06 16:28:56 -05:00
ar9485_initvals.h ath9k_hw: Enable manual peak calibration for AR9485 2013-05-17 14:31:08 -04:00
ar9565_1p0_initvals.h ath9k: Update initvals for AR9565 2013-05-08 17:15:08 -04:00
ar9580_1p0_initvals.h ath9k_hw: change AR9580 initvals to fix a stability issue 2013-04-12 13:22:09 -04:00
ath9k.h ath9k: limit multicast buffer hardware queue depth 2013-06-12 15:06:49 -04:00
beacon.c ath9k: limit multicast buffer hardware queue depth 2013-06-12 15:06:49 -04:00
btcoex.c ath9k: stomp audio profiles on weak signal strength 2012-11-21 14:16:01 -05:00
btcoex.h ath9k: stomp audio profiles on weak signal strength 2012-11-21 14:16:01 -05:00
calib.c Merge branch 'for-john' of git://git.kernel.org/pub/scm/linux/kernel/git/jberg/mac80211-next 2013-04-10 14:09:54 -04:00
calib.h ath9k_hw: make various ar5416/ar91xx rf banks const 2013-04-10 14:10:32 -04:00
common.c ath9k_common: remove ath9k_cmn_padpos 2013-04-10 14:10:33 -04:00
common.h ath9k_common: remove ath9k_cmn_padpos 2013-04-10 14:10:33 -04:00
debug.c Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless 2013-06-12 14:35:23 -04:00
debug.h Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless 2013-06-12 14:35:23 -04:00
dfs.c ath9k: change DFS logging to use ath_dbg() 2013-04-22 15:17:40 -04:00
dfs.h
dfs_debug.c ath9k: add debugfs based DFS radar simulation 2013-04-08 15:28:38 -04:00
dfs_debug.h
dfs_pattern_detector.c Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless 2013-04-23 14:09:39 -04:00
dfs_pattern_detector.h ath9k: change DFS logging to use ath_dbg() 2013-04-22 15:17:40 -04:00
dfs_pri_detector.c Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless 2013-04-23 14:09:39 -04:00
dfs_pri_detector.h ath9k: change DFS logging to use ath_dbg() 2013-04-22 15:17:40 -04:00
eeprom.c ath9k: allow to load EEPROM content via firmware API 2012-12-10 15:49:57 -05:00
eeprom.h ath9k: use 'struct ath_hw *' as the first argument for 'ath9k_hw_nvram_read' 2012-12-10 15:49:56 -05:00
eeprom_4k.c ath9k: use 'struct ath_hw *' as the first argument for 'ath9k_hw_nvram_read' 2012-12-10 15:49:56 -05:00
eeprom_9287.c ath9k: use 'struct ath_hw *' as the first argument for 'ath9k_hw_nvram_read' 2012-12-10 15:49:56 -05:00
eeprom_def.c ath9k: use 'struct ath_hw *' as the first argument for 'ath9k_hw_nvram_read' 2012-12-10 15:49:56 -05:00
gpio.c ath9k/ath9k_htc: Remove WME macros 2012-11-21 14:16:02 -05:00
hif_usb.c ath9k_htc: Add PID/VID for a Ubiquiti WiFiStation 2012-10-24 13:18:08 -04:00
hif_usb.h wireless: ath9k-htc: only load firmware in need 2012-09-07 15:03:36 -04:00
htc.h ath9k_htc: Add support for mesh interfaces 2013-05-22 15:05:33 -04:00
htc_drv_beacon.c ath9k_htc: Add support for mesh interfaces 2013-05-22 15:05:33 -04:00
htc_drv_debug.c ath9k/ath9k_htc: Remove WME macros 2012-11-21 14:16:02 -05:00
htc_drv_gpio.c ath9k/ath9k_htc: Remove WME macros 2012-11-21 14:16:02 -05:00
htc_drv_init.c ath9k_htc: Claim support for mgmt frame protection 2013-05-22 15:05:34 -04:00
htc_drv_main.c ath9k: Simplify ANI initialization 2013-06-03 15:55:47 -04:00
htc_drv_txrx.c ath9k_htc: Add support for mesh interfaces 2013-05-22 15:05:33 -04:00
htc_hst.c ath9k_htc: Fix memory leak 2013-01-11 14:12:01 -05:00
htc_hst.h
hw-ops.h ath9k_hw: use the devres API for allocations 2013-01-07 15:16:51 -05:00
hw.c Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless 2013-06-12 14:35:23 -04:00
hw.h ath9k: Do not maintain ANI state per-channel 2013-06-03 15:55:48 -04:00
init.c ath9k: add support for IEEE80211_TX_CTL_PS_RESPONSE 2013-06-12 15:06:49 -04:00
link.c ath9k: Simplify ANI initialization 2013-06-03 15:55:47 -04:00
mac.c Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless 2013-06-12 14:35:23 -04:00
mac.h ath9k: check for Rx-STBC flag and pass it to ieee80211 2013-05-30 14:42:35 -04:00
main.c ath9k: implement support for .release_buffered_frames() 2013-06-12 15:06:49 -04:00
mci.c ath9k: Remove unused variables in ath_mci_cleanup 2013-02-01 14:27:24 -05:00
mci.h ath9k: Add new BT profile info A2DP_Voice 2012-10-29 15:19:30 -04:00
pci.c ath9k: use the devres API for allocations/mappings 2013-01-07 15:16:51 -05:00
phy.h
rc.c ath9k: prevent aggregation session deadlocks 2013-05-22 14:28:44 -04:00
rc.h ath9k: Use minstrel rate control by default 2013-06-12 10:20:58 -04:00
recv.c ath9k: Return early for invalid rates 2013-06-03 15:55:45 -04:00
reg.h ath9k_hw: improve performance for AR934x v1.3+ 2013-05-24 12:50:22 -04:00
wmi.c
wmi.h
wow.c ath9k: Enable WoW only for AR9462 2013-06-03 15:55:46 -04:00
xmit.c ath9k: limit multicast buffer hardware queue depth 2013-06-12 15:06:49 -04:00