mirror of https://gitee.com/openkylin/linux.git
5fb234560e
The currently assigned IRQ number to the OHCI controller is incorrect for the AR7240 SoC, and that leads to the following error message from the OHCI driver: ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver ath79-ohci ath79-ohci: Atheros built-in OHCI controller ath79-ohci ath79-ohci: new USB bus registered, assigned bus number 1 ath79-ohci ath79-ohci: irq 14, io mem 0x1b000000 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected usb 1-1: new full-speed USB device number 2 using ath79-ohci ath79-ohci ath79-ohci: Unlink after no-IRQ? Controller is probably using the wrong IRQ. Fix this by using the correct IRQ number. Signed-off-by: Gabor Juhos <juhosg@openwrt.org> Cc: linux-mips@linux-mips.org Patchwork: https://patchwork.linux-mips.org/patch/4168/ Signed-off-by: Ralf Baechle <ralf@linux-mips.org> |
||
|---|---|---|
| .. | ||
| Kconfig | ||
| Makefile | ||
| Platform | ||
| clock.c | ||
| common.c | ||
| common.h | ||
| dev-common.c | ||
| dev-common.h | ||
| dev-gpio-buttons.c | ||
| dev-gpio-buttons.h | ||
| dev-leds-gpio.c | ||
| dev-leds-gpio.h | ||
| dev-spi.c | ||
| dev-spi.h | ||
| dev-usb.c | ||
| dev-usb.h | ||
| dev-wmac.c | ||
| dev-wmac.h | ||
| early_printk.c | ||
| gpio.c | ||
| irq.c | ||
| mach-ap81.c | ||
| mach-ap121.c | ||
| mach-db120.c | ||
| mach-pb44.c | ||
| mach-ubnt-xm.c | ||
| machtypes.h | ||
| pci.c | ||
| pci.h | ||
| prom.c | ||
| setup.c | ||