Remove definitions for TCG_AREGs corresponding to AREG definitions
removed in r6778.
Signed-off-by: Stuart Brady <stuart.brady@gmail.com>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6779 c046a42c-6fe2-441c-8c8c-71466251a162
Use firmware configuration device for boot device, kernel, initrd and
kernel command line parameters on PPC, Sparc32 and Sparc64.
Update OpenBIOS images to r479 which supports the change.
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6777 c046a42c-6fe2-441c-8c8c-71466251a162
Eliminate "mmc0: SD card claims to support the incompletely defined 'low voltage
range'. This will be ignored." warning. Qemu says the card is a SD card, and SD
spec doesn't define low-voltage cards, so do now pretend to be one.
Signed-off-by: Riku Voipio <riku.voipio@iki.fi>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6772 c046a42c-6fe2-441c-8c8c-71466251a162
According to ARM Cortex A8 Technical Reference Manual, the reset value for CP15 c1 auxiliary control
register is 2, not zero (page 3.12).
Signed-off-by: Riku Voipio <riku.voipio@iki.fi>
Acked-by: Laurent Desnogues <laurent.desnogues@gmail.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6771 c046a42c-6fe2-441c-8c8c-71466251a162
The current XML files claim, on floating point-supporting Power chips,
that $f0 is register 70. This would be fine, except that register 70
for non-XML-aware GDB is FPSCR. More importantly, 70 is less than
NUM_CORE_REGS (71) for Power, so a request for register 70 goes to the
"core" register reading routines, rather than the floating-point
register read routine we registered with gdb_register_coprocessor.
Therefore, when we are talking to an XML-aware GDB, we claim that
register has zero width, which causes the rest of QEMU's GDB stub to
send an error back to GDB, which causes GDB to be unable to read the
floating-point registers. (The problem is also present for SPE
registers and occurs in a slightly different way for Altivec registers.)
The best way to fix this is to have the "core register" XML files for
PPC32 and PPC64 claim that there is a 4-byte register 70, which causes
$f0 to be register 71, and everything works just fine from that point
forward.
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6770 c046a42c-6fe2-441c-8c8c-71466251a162
Altivec and SPE both have 34 registers in their register sets, not 35
with a missing register 32.
GDB would ask for register 32 of the Altivec (resp. SPE) registers and
the code would claim it had zero width. The QEMU GDB stub code would
then return an E14 to GDB, which would complain about not being sure
whether p packets were supported or not.
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6769 c046a42c-6fe2-441c-8c8c-71466251a162
Consistently use the C99 named initializer format for the BlockDriver
methods to make the method table more readable and more easily
extensible.
Signed-off-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6768 c046a42c-6fe2-441c-8c8c-71466251a162
Fix remaining arm warnings - except for the mess in the NetWinder FP
emulator.
Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6766 c046a42c-6fe2-441c-8c8c-71466251a162
Found while cleaning up compiler warnings: GIC_*_LEVEL macros strongly
suggest that gic_irq_state.level is intended to be per-CPU and not just
a single, global bit. I'm unable to test the effect, but it seems to be
the most reasonable fix for the apparent brokenness.
Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6765 c046a42c-6fe2-441c-8c8c-71466251a162
The 970 doesn't know BAT, so let's not search BATs there.
This was only in as a hack for OpenHackWare so it would
work on PPC64.
Signed-off-by: Alexander Graf <alex@csgraf.de>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6759 c046a42c-6fe2-441c-8c8c-71466251a162
Real 970 CPUs have the SLB not memory backed, but inside the CPU.
This breaks bridge mode for 970 for now, but at least keeps us from
overwriting physical addresses 0x0 - 0x300, rendering our interrupt
handlers useless.
I put in a stub for bridge mode operation that could be enabled
easily, but for now it's safer to leave that off I guess (970fx doesn't
have bridge mode AFAIK).
Signed-off-by: Alexander Graf <alex@csgraf.de>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6757 c046a42c-6fe2-441c-8c8c-71466251a162
CPU_INTERRUPT_EXIT is not set anymore in env->interrupt_request since
revision 6728. Make sure the bit is cleared on VM load.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6756 c046a42c-6fe2-441c-8c8c-71466251a162
ctx->nx only got ORed, but never reset. So when one page in the
lifetime of the VM was ever NX, all later pages were too.
Signed-off-by: Alexander Graf <alex@csgraf.de>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6755 c046a42c-6fe2-441c-8c8c-71466251a162
The current implementation masks some MSR bits from SRR1 as it is
given on rfi(d). This looks pretty wrong and breaks Altivec.
Signed-off-by: Alexander Graf <alex@csgraf.de>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6754 c046a42c-6fe2-441c-8c8c-71466251a162
Mtfsf can have the L bit set, so all the register contents get stored
in FPSCR. Linux uses it, so let's implement it.
Signed-off-by: Alexander Graf <alex@csgraf.de>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6753 c046a42c-6fe2-441c-8c8c-71466251a162
Real 970s enable MSR_SF on all interrupts. The current code didn't do
this until now, so let's activate it!
Signed-off-by: Alexander Graf <alex@csgraf.de>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6752 c046a42c-6fe2-441c-8c8c-71466251a162
Linux tries to access some SPRs on PPC64 boot. Let's just ignore those
for the 970fx for now to make it happy.
Signed-off-by: Alexander Graf <alex@csgraf.de>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6751 c046a42c-6fe2-441c-8c8c-71466251a162
Linux tries to poke the AGP bridge port and is pretty sad when it can't,
so let's activate the old code again and throw out the bit modifications,
as we don't really do anything with the values anyways.
Signed-off-by: Alexander Graf <alex@csgraf.de>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6750 c046a42c-6fe2-441c-8c8c-71466251a162
Linux uses tlbiel to flush TLB entries in PPC64 mode. This special TLB
flush opcode only flushes an entry for the CPU it runs on, not across
all CPUs in the system.
Signed-off-by: Alexander Graf <alex@csgraf.de>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6749 c046a42c-6fe2-441c-8c8c-71466251a162
The current SLB/PTE code does not support large pages, which are
required by Linux, as it boots up with the kernel regions up as large.
This patch implements large page support, so we can run Linux.
Signed-off-by: Alexander Graf <alex@csgraf.de>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6748 c046a42c-6fe2-441c-8c8c-71466251a162
In order to modify SLB entries on recent PPC64 machines, the slbmte
instruction is used.
This patch implements the slbmte instruction and makes the "bridge"
mode code use the slb set functions, so we can move the SLB into
the CPU struct later.
This is required for Linux to run on PPC64.
Signed-off-by: Alexander Graf <alex@csgraf.de>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6747 c046a42c-6fe2-441c-8c8c-71466251a162
Update i386-dis.c again using binutils files from CVS:
include/opcode/i386.h r1.78 and opcodes/i386-dis.c r1.126.
These are the last versions using GPL v2+.
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6744 c046a42c-6fe2-441c-8c8c-71466251a162
and process termination in legacy applications. Try to guess which we want
based on the presence of multiple threads.
Also implement locking when modifying the CPU list.
Signed-off-by: Paul Brook <paul@codesourcery.com>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6735 c046a42c-6fe2-441c-8c8c-71466251a162
Major FAIL with my checkin scripts.
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6731 c046a42c-6fe2-441c-8c8c-71466251a162
env->interrupt_request is accessed as the bit level from both main code
and signal handler, making a race condition possible even on CISC CPU.
This causes freeze of QEMU under high load when running the dyntick
clock.
The patch below move the bit corresponding to CPU_INTERRUPT_EXIT in a
separate variable, declared as volatile sig_atomic_t, so it should be
work even on RISC CPU.
We may want to move the cpu_interrupt(env, CPU_INTERRUPT_EXIT) case in
its own function and get rid of CPU_INTERRUPT_EXIT. That can be done
later, I wanted to keep the patch short for easier review.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6728 c046a42c-6fe2-441c-8c8c-71466251a162
blueswir1